Pelco dx8100-exp installation manual Power on the DX8100, Restarting the Unit

Page 17

4. Power on the DX8100.

Figure 16. Restarting the Unit

5.Log in to the DX8100 and verify that the additional devices are displayed in the DX8100 site tree. For information about the additional features provided by the Expansion Unit, refer to Table A on page 4.

6.This completes the Expansion Unit installation process.

The DX8100 DVR does not have to be powered down to connect devices to the Expansion Unit.

To connect devices to the Expansion Unit:

1.Power down the Expansion Unit by disconnecting the 68-pin Expansion cable end at the Expansion Unit. The Expansion Unit is powered down.

2.Connect the additional devices to the Expansion Unit.

3.Reconnect the 68-pin Expansion cable end to the Expansion Unit. The Expansion Unit is powered up.

4.Configure the DX8100 to work with the new devices attached to the Expansion Unit.

C2636M-B (4/07)

17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents DX8100-EXP Expansion Unit Installation Manual Page This document is organized into the following sections IntroductionParts List Table D. DX8100 Optional Accessories Other DX8100 Optional AccessoriesTools Needed Table C. DX8100 Expansion Unit Kit ItemsGetting Ready Unplug the power cord from the wall socketC2636M-B 4/07 Open the DX8100 Chassis Prepare DX8100 for Expansion Unit InstallationComponent Layout Slot 1 PTZ card installed in PCI connectorTV/Audio cable Video ribbon cable 32-pin DX8100 I/O card Install the DX8100 I/O CardInstalling the DX8100 I/O Card Pin ribbon cable Installing the Capture CardInstalling the Optional Capture Card To reassemble the DX8100 Reassemble the UnitConnecting the Expansion Unit to the DX8100 Interfacing the Expansion Unit and DX8100 Restarting the Unit Power on the DX8100Revision History Product Warranty and Return Information ISO9001
Top Page Image Contents