FUNAI BZV420MW8 Video cont’d, Progressive Scan Default OFF, TV Aspect Default 43 Letter Box

SETUPS

Video (cont’d)

1 Progressive Scan (Default : OFF)

This unit is compatible with the progressive scan system. The feature provides you with the higher definition images than the traditional output system does. To utilize this feature, you must set progressive scan mode to “ON”.

1) Use [K / L] to select “ON“, then press [OK].

General Setting
Playback
Display	Progressive Scan
Video	TV Aspect
Recording	Progressive Scan
	Video Input
Clock	ON
	OFF
Reset All

2) Use [{ / B] to select “Yes“, then press [OK].

General Setting

Playback				scan:
Activating progressive
Display		TV has		Progressive Scan
Check your			progressive scan
Video				TV Aspect
and connect		withProgressivecomponentScanvideo cable.
Recording				Select Video
Clock		ON
Reset All		OFF
NOTE :
	If there is no picture or picture is
	distorted after selecting “Yes”,
	Wait about 15 seconds for auto recovery.
	Activate?				Yes	No

3)Use [K / L] to select “Yes“ within 15 seconds, then press [OK].

Your setting will be activated.

2 TV Aspect (Default: 4:3 Letter Box)

You should select the TV aspect ratio to match the TV that you are connecting to the unit. You either have a standard 4:3 TV or a widescreen TV (16:9 rectangular).

Use [K / L] to select your desired option, then press [OK].

General Setting
Playback
Display	Progressive Scan
Video	TV Aspect TV Aspect
Recording	Video Input
Clock	4:3 Letter Box
Reset All	4:3 Pan & Scan
	16:9 Wide

If you have a standard TV:

Select “4:3 Letter Box” or “4:3 Pan and Scan”. The “4:3 Letter Box” setting will display the entire widescreen DVDs on your standard TV, by placing black bars at the top and bottom of the picture, like a normal DVD player does. The “4:3 Pan and Scan” setting will fill the screen vertically, but both sides of the widescreen DVDs will be trimmed. Standard video input and standard DVDs will appear normal with either setting.

If you have a widescreen TV:

Select the “16:9 Wide” setting. Widescreen DVDs will fill the screen appropriately. To watch standard 4:3 video, use your TV’s aspect control to set the screen to your liking.

Introduction Connections Basic Setup Recording Playback

Note

•If your TV is compatible with progressive scan (525p / 480p), you are recommended to use the component video cable (commercially available) to connect this unit to the TV. (Refer to “Method 2” on page 14.) If not, use the RCA video cable and set the progressive scan to “OFF” or press and hold [SETUP] for more than 3 seconds during DVD playback.

•When selecting “No” or not pressing any buttons on the unit or remote control within 15 seconds at step 3, progressive scan remains to be “OFF” (interlace scan).

EN 75

Editing Function Setup VCR Functions Others

Español