Marmitek 250205, 20095 owner manual Resetting the configuration of the remote control

5.Press the SOURCE and CHAN UP buttons (right button) at the front of the transmitter at the same time.

6.The following text will appear on your screen:

HANDSET CODE 636

PRESS [SET] TO CHANGE

OR

ANY OTHER KEY TO CONTINUE

7. Press "SET". The following text will appear on your screen:

PRESS [SET] AGAIN TO

CONFIRM

8.Press "SET" again.

9.The following text will appear on your screen (where XYZ is the new code):

CODE XYZ ACCEPTED

10. Test the connection by pressing PROG+ or PROG-.

7.8 Resetting the configuration of the remote control

You can reset the remote control to its original configuration, as follows:

1.Press the SETUP button until the LED stays lit.

2.Press the STOP button twice and then press the MUTE button once.

3.The LED will extinguish.

18 MARMITEK