JVC LPT0002-027B specifications Engage Insert Editing, Start Editing, END Insert Editing

INSERT PLAY

		8
6		5/8
q	1	Á

A. DUB

	2
1	2	3
4	5	6
7	8	9
C.RESET	0	4
		PLAY

		E	N	39
6	ENGAGE INSERT EDITING
	Press INSERT.
	● Your recorder enters the Insert-Pause mode. (" ", " "
	and " " light up on the front display panel.)
	● The TV screen changes from the still picture to the
	input source you are going to record.
7	START EDITING
	Load the source cassette and play back the segment
	that is to be inserted. When you reach the start of the
	section of the source tape that you wish to insert, press
	PLAY to start the tape in your recorder; Insert Editing
	begins at this point.
	● " " and " " are displayed on the front display
	panel.
8	END INSERT EDITING
	At counter "0:00:00", Insert Editing will stop automati-
	cally while the tape continues running in the Play
	mode. if you wish to stop Insert Editing before the
	specified edit-out point, press C.RESET.

FOR AV INSERT EDITING

If you want to replace the picture, Hi-Fi audio soundtrack and normal audio soundtrack all at the same time...

In step 6 above, after you press INSERT, press A. DUB also. (" " and " " blink and " " lights up on the front display panel.)

3

1

NOTES:

●Suitable leads can be obtained from your dealer.

●Insert editing is not possible with cassettes whose safety tab has been removed.

●When insert editing is performed on a tape that has been recorded on another video recorder, the inserted portion may appear distorted.

●In insert editing, the recording speed (SP/LP) is determined by the previous recording to be replaced. If the previous recording's speed changes within a single edit, the inserted picture will be distorted at the switching point.

●A small portion of the recording which precedes an insert edit may become erased.

●Insert Editing is also possible using the rear panel AV1 IN/ OUT or AV2 IN connector. When using these connectors, make sure to select the correct input mode in step 2.