JVC HR-J668EU, HR-J711EU specifications Auto SP→LP Timer, Auto Timer

Auto SP→LP Timer

If, when timer-recording in SP mode, there is not enough tape to record the entire programme, the recorder automatically switches to LP mode to allow complete recording.

For Example . . .

Recording a programme of 210 minutes in length onto a 180- minute tape

Approximately 150 minutes	Approximately 60 minutes
SP mode	LP mode

Total 210 minutes

Make sure you set "AUTO SP→LP TIMER" to "ON" at the Mode Set screen before the timer-recording starts.

ACCESS MAIN MENU SCREEN

1	Press MENU.
2		ACCESS MODE SET SCREEN
	Press %Þ to move the highlight bar (pointer) to "MODE
		SET", then press OK or #.
3		SELECT MODE
	Press %Þ to move the		MODE SET
		highlight bar (pointer) to	B. E. S. T.	ON
		"AUTO SP→LP TIMER",
			PICTURE CONTROL	AUTO
		then press OK or #to select	AUTO TIMER	OFF
		"ON".	O. S. D.	ON
			DIRECT REC	ON
			AUTO SP=LP TIMER	ON
			POWER SAVE	OFF
			NEXT PAGE
			[5°] =
			[MENU] : EXIT
4		RETURN TO NORMAL SCREEN
	Press MENU.

NOTES:

●If you have programmed the recorder to timer-record 2 or

more programmes, the second programme and those thereafter may not fit on the tape if you set "AUTO SP→LP TIMER" to "ON". In this case, make sure the mode is not engaged, then set the tape speed manually during timer programming.

●In order to ensure that the recording fits on the tape, this feature may leave a slight non-recorded section at the end of the tape.

●There may be some noise and sound disturbance at the point on the tape where the recorder switches from SP to LP mode.

●The Auto SP→LP Timer feature is not available during ITR (Instant Timer Recording), and the feature will not work properly with any tapes longer than E-180 or with some tapes of shorter lengths.

●If you perform timer recording with both VPS/PDC and the Auto SP→LP Timer activated, and the programme goes beyond its originally scheduled length, there may be times when the programme cannot be recorded in its entirety.

EN27

Auto Timer

When the Auto Timer is set to ON the timer is automatically engaged when the recorder power is turned off and automati- cally disengaged when the recorder is powered back on.

ACCESS MAIN MENU SCREEN

1 Press MENU.
		ACCESS MODE SET SCREEN
	Press %Þ to move the		MAIN MENU
		highlight bar (pointer) to
2 "MODE SET", then press			MODE SET
			AUTO CH SET
		OK or #.	MANUAL CH SET
			INITIAL SET
			[5°] =
			[MENU] : EXIT
3		SELECT MODE
	Press %Þ to move the		MODE SET
		highlight bar (pointer) to	B. E. S. T.	ON
		"AUTO TIMER", then press
			PICTURE CONTROL	AUTO
		OK or #to select either
			AUTO TIMER	OFF
		"ON" or "OFF".	O. S. D.	ON
			DIRECT REC	ON
			AUTO SP=LP TIMER	OFF
			POWER SAVE	OFF
			NEXT PAGE
			[5°] =
			[MENU] : EXIT
		RETURN TO NORMAL SCREEN
4 Press MENU.

NOTE:

For safety, when Auto timer is set to "OFF", all other recorder functions are disabled while the Timer mode is engaged. To disengage the timer, press ä (TIMER).