JVC HR-S9911U specifications Tuner Setting, Cable Box and/or DBS Receiver Control Setting

Tuner Setting

●Turn on the VCR and TV, and select the VCR channel (or AV mode).

●Set the VCR/TV/CABLE/DBS selector on the Remote to “VCR”.

Setting channels automatically

— Auto Channel Set

Perform Auto Channel Set only if channels have not been set correctly by the Plug&Play setting.

A Access Main Menu screen, then Tuner

Set screen

Press MENU on the Remote. Press rt to move the highlight bar (arrow) to “TUNER SET”, then press OK or e.

B Perform Auto Channel Set

Press rt to move the highlight bar (arrow) to “AUTO CHANNEL SET”, then press OK or e. The VCR selects the correct band (TV or CATV) automatically during Auto Channel Set.

● When Auto Channel Set is complete, “SCAN COMPLETED” appears on screen.

●If the scan was unsuccessful, “SCAN COMPLETED–NO SIGNAL–” appears on screen. Check the connections and start again.

Press MENU to return to normal screen.

Setting channels manually

— Manual Channel Set

You can add the channels you want or delete the channels you do not want manually.

A Access Main Menu screen, then Tuner

Set screen

Press MENU on the Remote. Press rt to move the highlight bar (arrow) to “TUNER SET”, then press OK or e.

B Access Manual Channel Set screen

Press rt to move the highlight bar (arrow) to “MANUAL CHANNEL SET”, then press OK or e.

C Add or skip desired channels

To add channels

A Press the Number keys on the Remote to input a channel number you want to add.

B Press OK or e to set to “ADD”.

CRepeat A to B to add other channels. Press MENU to return to normal screen.

To skip channels

APress rtor the Number keys to select a channel number you want to skip.

BPress OK or e to set to “SKIP”.

CRepeat A and B to skip other channels. Press MENU to return to normal screen.

After a power failure occurs, band selection will be reset to “CATV”.

Cable Box and/or DBS Receiver Control Setting

The following procedure is required if you receive your TV channels through a cable box (descrambler) and/or if you receive satellite channels through DBS (Direct Broadcast Satellite) receiver. The supplied Controller allows the VCR to automatically switch the cable box or DBS receiver’s channel during timer recording.

NOTES:

●For the cable box, the Controller is effective for VCR Plus+ system or Express timer programing.

●For the DBS receiver, the Controller is effective only for Express timer programing.

●When connecting your cable box or DBS receiver, refer to its instruction manual.

●Turn on the VCR and TV, and select the VCR channel (or AV mode).

●Set the VCR/TV/CABLE/DBS selector on the Remote to “VCR”.

ASituate Controller

If both a cable box and a DBS receiver are used, position the Controller so its signal reaches the remote sensors on both the cable box and DBS receiver.

BAttach Controller

Fix securely using the adhesive strip attached on the back of the Controller.

Cable box or DBS receiver

Your VCR	Controller
	(suggested locations)

CConnect cable box and/or DBS receiver to VCR

	Cable box or DBS receiver
Transmitter	RF output	Audio/video output
Controller		or
	To ANTENNA IN	To AUDIO/VIDEO IN
		VCR

●If your cable box or DBS receiver does not have audio/video output connectors, connect the RF output terminal on the unit to the ANTENNA IN terminal on the rear of your VCR.

●If your cable box or DBS receiver has audio/video output connectors, connect an audio/video cable between the AUDIO/ VIDEO IN connectors on the rear of the VCR and the audio/ video output connectors on the unit.

●If both a cable box and a DBS receiver are used, it is recommended that you connect the DBS receiver to your VCR’s AUDIO/VIDEO IN connectors and the cable box to your VCR’s ANTENNA IN connector.

— 8 —