JVC HR-S9400EH Activate Scene Finder, Stop Scene Finder, SET A/B Code Switch, RE-SUPPLY Power

Scene Finder

This function helps you check contents of unlabeled recorded tapes at the touch of a single button.

SearchSearchSearch

FF	REW FF	REW FF	REW
5 seconds	10 minutes 5 seconds	10 minutes	5 seconds
	on counter	on counter

NOTE:

Scene Finder cannot be used when the recorder is in the Record mode.

ACTIVATE SCENE FINDER

1 Press SCENE FINDER. The recorder starts forward search for 5 seconds and then fast-forwards 10 minutes on the counter. This cycle is repeated until the end of the tape is reached.

●To start Scene Finder in the reverse direction, press SCENE FINDER and then press the REW button within 2 seconds. This cycle is repeated until the beginning of the tape.

●During Scene Finder, the following indications appear on the display panel:

STOP SCENE FINDER

2 Press STOP.

NOTES:

●During Scene Finder search, you can also hear the tape sound. During fast forward or rewind, you hear the current TV sound instead.

●During Scene Finder, the sound can be heard regardless of "TIME SCAN AUDIO" setting. ☞ pg. 22.

●Scene Finder does not function during Index Search.

Next Function Memory

You can set your recorder's power to go off automatically after the tape is fully rewound. Before starting, make sure the recorder is in the Stop mode.

For Automatic Power Off After Tape Rewind . . .

. . . press REW, then press within 2 seconds.

NOTE:

If you want the power to be turned off automatically when the counter reads “0:00:00” (instead of at the beginning of the tape), press C.MEMORY so that the “M” mark appears before pressing REW.

EN19

Remote A/B Code Switching

The remote control is capable of controlling two JVC video recorders independently; one set to respond to the remote control’s A code control signals and another set to respond to B code control signals. The remote control is preset to send A code signals because your video recorder is initially set to respond to A code signals. You can easily modify your video recorder to respond to B code signals.

1	REMOVE POWER SUPPLY
	Unplug the mains power cord from the mains outlet.
2	SET A/B CODE SWITCH
	Set to B.
3	RE-SUPPLY POWER
	Plug the mains power cord back into the mains outlet.
4	TURN THE RECORDER ON
	Press	on the remote control. The recorder will now
	only respond to B code signals.

NOTE:

Some TV sets may malfunction in response to the B mode. If this happens, switch back to the A mode.

Counter Memory

Returns to the counter reading of “0:00:00” to conveniently find a specific place on the tape automatically.

1	SET COUNTER MEMORY
	Press C. RESET during playback at a point you wish to
	locate later. The counter reads “0:00:00”. Then press
	C.MEMORY, and “M” appears in front of the counter
	digits.

	ACTIVATE COUNTER
2	MEMORY
	When you wish to return to the designated point, press
	STOP and then REW or FF.
	● The tape rewinds or fast-forwards and stops at about
	0:00:00 automatically.
	● To cancel Counter Memory, press C.MEMORY again.