8
LOCATE EDIT-IN POINT
Find the point on the source 
tape from where you want 
the edited scene to begin by pressing PUSH JOG Þ %or using the TIME SCAN
SHUTTLE ring or the JOG
dial, then press IN/OUT.0:00:00
(+) 0:00:00
● The
●You can also perform an Index Search (if index marks have been previously recorded on the tape at the desired points) to find the points you want, but this will result in reduced accuracy.
LOCATE EDIT-OUT POINT
E
N
43
NOTES:
● You can also monitor the sound when searching for scenes you want to edit in steps 8 – 9. Since you can hear the soundtrack during selection, you can avoid abrupt or unnatural sounding
● When editing, there may be a discrepancy of about 2 seconds on the source tape between the locations you chose as
● For any scene, the
● Since the source recorder prerolls during Random Assemble Editing, there must be at least 15 seconds worth of recorded material prior to any
● If the search time for an
● During steps 8 and 9 — if you engage the Pause mode while registering
9
Find the point where you want the edited scene to end by pressing PUSH JOG Þ %or using the TIME SCAN SHUTTLE ring or the JOG dial, then press
IN/OUT.
● The
=1 | 0:02:23 |
2 |
|
3
4
5
6
7
8
0:02:23
(+) 0:00:00
[MENU] : EXIT
=1 0:02:23 0:02:51 
2
3
characters in the
To Make Corrections . . .
. . . during step 8 or 9, you can cancel registered in and out points by pressing CANCEL on the remote control. Each time you press, the preceding point is erased.
● If, for example, you have registered 5 sets of in and out points and want to reset the first set, you have to press CANCEL until all points after the first set have been erased. Reenter them after you've repaired the first set of points.
● The total time of the edited scenes is displayed to the right of "(+)".
● Repeat steps 8 and 9 for each additional scene.
4
5
6
7
8
0:02:51
(+) 0:00:28
[MENU] : EXIT
Memory Capacity
Random Assemble Editing shares memory space with the recorder's timer. If there are programs occupied by
PROGRAM FULL
10
PREPARE RECORDING DECK
Engage its
register
0:00:00
(+) 0:00:00
[MENU] : EXIT
11
12
START R.A. EDIT
Press START.
●Automatic editing begins; all the specified scenes are copied to the recording deck in the order they were registered.
●The
●During scene search, the recording deck automati- cally enters its
●When all registered scenes have been edited, your recorder enters the Pause mode, the recording deck enters its
END R.A. EDIT
Press MENU to return to the normal screen, and engage the Stop mode for your recorder and for the recording deck.
●When all 8 programs are full,
"PROGRAM FULL" appears on the R.A. EDIT screen.
●To cancel a program, see page 32.
RM-V704U Multi-Brand R.A. Edit Controller (Not provided)
By connecting this controller to your recorder's R.A. EDIT connector, you can perform Random Assemble Editing in combination with a second
NOTE:
Although the