| EN 61 |
| * The default setting is bold in the table below. |
|
|
8 DIGITAL 3R | When this function is set to “ON”, the Digital 3R picture |
ON | system applies edge correction to the luminance signal to |
OFF | enhance detail. |
| NOTES: |
| ● Normally it is recommended to keep “DIGITAL 3R” set to |
| “ON”. |
| ● Depending on the type of tape being used, picture quality may |
| be better with “DIGITAL 3R” set to “OFF”. |
| ● If you use the recorder as the source player for editing, be sure |
| to set “DIGITAL 3R” to “OFF” before starting. |
|
|
8 POWER SAVE | When this function is set to “ON”, you can reduce the |
ON | power consumption while the recorder is turned off. |
OFF | NOTES: |
| |
| ● During Power Save mode ... |
| ... the front display panel will be turned off. |
| ... the Just Clock function ( pg. 70) does not work. |
| ... the picture may be distorted momentarily when you turn on/ |
| off the recorder. |
| ● Power Save does not work when ... |
| ... the recorder is in the Timer mode. |
| ... the recorder’s power is turned off after |
| Instant Timer Recording. |
| ... the Automatic Satellite Programme Recording mode is |
| engaged ( pg. 37). |
| ... |
|
|
8 VIDEO STABILIZER | When this function is set to “ON”, you can automatically |
ON | correct vertical vibration in the picture when playing back |
OFF | unstable recordings made on another recorder. |
| NOTES: |
| ● When you finish viewing a tape, be sure to set this function to |
| “OFF”. |
| ● Regardless of the setting, this function has no effect during |
| recording and during special effects playback. |
| ● The |
| set to “ON”. |
| ● To watch recordings with |
| “OFF”. |
| ● Video Stabilizer and Digital TBC/NR cannot be used at the same |
| time. If you activate Digital TBC/NR when “VIDEO STABILIZER” |
| is set to “ON”, Video Stabilizer will be automatically turned |
| “OFF”. |
|
|