JVC HR-J439EE manual Activate Instant Review, Activate Repeat, Playback, Activate Scene Finder

12ENPLAYBACK (cont.)

Instant ReView

Simply by pressing a single button, the recorder power comes on, rewinds, and begins playback of the last timer-recorded programme. If you have several programmes recorded, you can easily access any of them.

NOTES:

●Before starting, make sure that the recorder is off and that the Timer mode is disengaged.

●Turn on the TV and select the VIDEO channel (or AV mode).

ACTIVATE INSTANT

REVIEW

1 Press REVIEW. The recorder power comes on and the recorder searches for the index code indicating the start of the last timer-recorded programme. Once it’s found, playback begins automatically.

If you have, for example, 3 programmes and wish to watch the first of the 3 programmes, press REVIEW three times. The recorder searches and begins playback automatically. You can access a programme as far as 9 index codes away from the current tape position.

NOTE:

Instant ReView is not possible while the recorder is in the Timer mode.

Repeat Playback

Your video recorder can automatically play back the whole tape 20 times repeatedly.

1	START PLAYBACK
	Press PLAY.
	ACTIVATE REPEAT
2	PLAYBACK
	Press PLAY and hold for over 5 seconds, then release.
	● "PLAY" on the display panel blinks slowly.
	● The tape plays 20 times automatically, and then
	stops.
3	STOP PLAYBACK
	Press STOP at any time to stop playback.

Scene Finder

This function helps you check contents of unlabeled recorded tapes at the touch of a single button.

SearchSearchSearch

FF	REW FF	REW FF	REW
5 seconds	10 minutes 5 seconds	10 minutes	5 seconds
	on counter	on counter

NOTE:

Scene Finder cannot be used when the recorder is in the Record mode.

ACTIVATE SCENE FINDER

1 Press SCENE FINDER. The recorder starts forward high- speed search for 5 seconds and then fast-forwards 10 minutes on the counter. This cycle is repeated until the end of the tape is reached.

●To start Scene Finder in the reverse direction, press SCENE FINDER and then press the REW button within 2 seconds. This cycle is repeated until the beginning of the tape.

●During Scene Finder, "PLAY" appears blinking on the display panel. During fast forward or rewind, " "

or " " appears on screen.

STOP SCENE FINDER

2 Press STOP.

NOTES:

●During Scene Finder high-speed search, you can also hear the tape sound. During fast forward or rewind, you hear the current TV sound instead.

●Scene Finder does not function during Index Search.

Tape Position Indicator

The tape position indicator appears
on screen when, from the Stop
mode, you press FF, REW or
perform an Index Search. The
position of “5” in relation to “0”			3
(beginning) or “+” (end) shows you	0	+		+	+
where you are on the tape.					1:23:45

”O.S.D.” (☞ pg. 5) must be set to “ON”, or the indicator will not appear.

NOTE:

Depending on the type of tape used, there may be times when the indication is not correct.

NOTE:

Pressing PLAY, REW , FF or PAUSE also stops Repeat Playback.