JVC HR-J439EE manual SET A/B Code Switch, RE-SUPPLY Power, SET Counter Memory, Activate Counter

Index Search

Your recorder automatically marks

index codes at the beginning of£ 2 each recording. This function gives

you quick access to any one of 9 index codes in either direction.

NOTE:

Before starting, make sure the recorder is in the Stop mode.

ACTIVATE INDEX SEARCH

1 Press PUSH JOG% or % (ª or £). “ª 1” or “£1” is displayed on screen and search begins in the corresponding direction.

●To access index codes 2 through 9, press PUSH JOG

% or % repeatedly until the correct index number is displayed.

Ex.: To locate the beginning of B from the current position, press PUSH JOG % twice.

To locate the beginning of D from the current position, press PUSH JOG %once.

Current position

A	B		C	D	E		F
–2		–1	1	2		3
		%		%

Index number

●When the specified index code is located, playback begins automatically.

EN13

Remote A/B Code Switching

The remote control is capable of controlling two JVC video recorders independently; one set to respond to the remote control’s A code control signals and another set to respond to B code control signals. The remote control is preset to send A code signals because your video recorder is initially set to respond to A code signals. You can easily modify your video recorder to respond to B code signals.

1	REMOVE POWER SUPPLY
	Unplug the mains power cord from the mains outlet.
2	SET A/B CODE SWITCH
	Set to B.
3	RE-SUPPLY POWER
	Plug the mains power cord back into the mains outlet.
4	TURN THE RECORDER ON
	Press OPERATE on the remote control. The recorder
	will now only respond to B code signals.

NOTE:

Some TV sets may malfunction in response to the B mode. If this happens, switch back to the A mode.

Counter Memory

Returns to the counter reading of “0:00:00” to conveniently find a specific place on the tape automatically.

1	SET COUNTER MEMORY
	Press C. RESET during playback at a point you wish to
	locate later. The counter reads “0:00:00”. Then press C.
	MEMORY, and “M” appears on the front display panel.

	ACTIVATE COUNTER
2	MEMORY
	When you wish to return to the designated point, press
	STOP and then REW or FF.
	● The tape rewinds or fast-forwards and stops at about
	0:00:00 automatically.
	● To cancel Counter Memory, press C.MEMORY again.

Next Function Memory

You can set your recorder's power to go off automatically after the tape is fully rewound. Before starting, make sure the recorder is in the Stop mode.

For Automatic Power Off After Tape Rewind . . .

. . . press REW, then press OPERATE within 2 seconds.

NOTE:

If you want the power to be turned off automatically when the counter reads “0:00:00” (instead of at the beginning of the tape), press C.MEMORY so that the “M” mark appears before pressing REW.