JVC HR-J430KR Engage Manual Tracking Mode, Adjust Manual Tracking, RE-ENGAGE Automatic Tracking

Page 16

PLAYBACKANDRECORDINGFEATURES(cont.)

Manual Tracking

Once playback begins, the VCR’s automatic tracking function is engaged. If noise appears in the picture, you can override this and make the adjustment manually.

°5

1 2 3

7 8 9

ENGAGE MANUAL

TRACKING MODE

1 During playback, press the CH5° buttons on the VCR's front panel simultaneously to cancel the automatic tracking mode and enable manual tracking adjust.

ADJUST MANUAL

TRACKING

2 Press CH5° on the VCR's front panel or remote. Press lightly for fine adjust, or press and hold for coarse adjust. Watch the screen and continue adjusting until optimum picture and sound quality are achieved.

RE-ENGAGE AUTOMATIC TRACKING

3 Press the CH5° buttons on the VCR's front panel simultaneously.

●When automatic tracking is re-engaged, video calibration is automatically activated.

NOTE:

During slow-motion playback, simply press CH5 or ° on the VCR's front panel or remote to adjust tracking.

Image 16

Contents HR-J430KR Dear Customer Do not place the VCRContents Basic Connections SET Date and Time ClockMake Corrections Tuner Perform Auto Channel SET Return to Normal ScreenAccess Tuner SET Screen Access AFC ScreenMake Selection Store Desired ChannelCode Setup Access Main Menu ScreenAccess Initial SET Screen Access G-CODE SET-UP ScreenAccess Guide Channel SET Screen Input Guide Channel NumberInput Receiving Channel Number Return to G-CODE SET UP ScreenReturn to Normal Simple Playback Load a CassetteFind Program Start Point Start PlaybackSimple Recording Pause During Playback Activate FRAME-BY Frame PlaybackStill Picture/Frame-By- Frame Playback Slow Motion/ Reverse Slow MotionActivate VARIABLE-SPEED Search Activate HIGH-SPEED SearchVariable-Speed Search Reverse Play High-Speed SearchEngage Manual Tracking Mode Adjust Manual TrackingRE-ENGAGE Automatic Tracking Manual TrackingAccess Superimpose Access Function SETSuperimpose Access Distant Code Skip Over Unwanted SectionsStart Repeat Stop RepeatActivate Instant Review Activate CounterMemory Return to Counter Position ZeroTape Position Indicator Relation to B Beginning or E End shows you where you are onPress REW, then press Timer within 2 seconds Next-Function MemoryAccess B.E.S.T. Picture System Screen Select ModeS.T. Picture System PreparationRecording Press and hold RECQuality of the tape Use, then recording Begins with the picture Level optimizedPlayback Tape in useEngage TV Mode Reset Counter to ZeroRecording Select Channel for ViewingInstant Timer Recording ITR Engage ITR ModeSET Recording Duration Press RECAccess G-CODE Screen Code Timer ProgrammingEnter G-CODE Number CHECK/CORRECT Input Engage Timer ModeData On-Screen Timer Programming Access ON-SCREENAccess Program SET Screen MenuSET Program Information ExampleDisengage Timer Cancel a ProgramRE-ENGAGE Timer Check And Cancel ProgramsAccess Auto SP/EP Auto SP/EP TimerPlace the arrow next to Auto SP/EP Timer by Pressing CH 5 or Push JOG 5, then press OKAccess Auto Timer Auto TimerSpecial Features 19, 20Edit From a Camcorder SET RECORDER’S Input Mode Edit To Or From AnotherLoad Cassettes Control Two JVC VCRsRandom As- semble Editing Prepare for EditingEND R.A. Edit Start R.A. EditTroubleshooting Cassette gets stuck partwayTimer again Re-perform the G-Code setup Doesn’t work properlyWhen scanning channels, some Has not been programmed correctly Cassette is automaticallyQuestions and Answers EIA monochrome signal Maximum recording time 210 min. with ST-210 video630 min. with ST-210 video Frequency-synthesized tunerRamdom Assemble Editing connector pg IndexRemote Control Provided Front Display PanelHR-J430KR