JVC HR-E639EE S.T. Picture System, Access Mode Select, EN Recording, Confirm B.E.S.T. Status

18ENRECORDING(cont.)

B.E.S.T. Picture System

Turn on the TV and select the VIDEO channel (or AV mode).

	000	0
000		0000
	0	000
000		0000
000		0
00		00
00		00
00		00
00		00

RECORD

1 2 3

4 5 6

7 8 9

0

TV PROG.

PLAY

RECORD

OK

OSD ( )

The B.E.S.T. (Biconditional Equalised Signal Tracking) system checks the condition of the tape in use during recording and playback, and compensates to provide the highest-possible recording and playback pictures. The default setting is "ON".

Recording

1	LOAD A CASSETTE
	Insert a cassette with the record safety tab intact.
	● The recorder power comes on automatically.
	ACCESS MODE SELECT
	SCREEN
	Press OSD(	) and the Language screen appears. (To
	change the language, ☞ pg. 5) Press OK on the remote
2 control.
	CONFIRM B.E.S.T. STATUS
	The default setting is
	“ON”. If this is the case,
3 go to step 4. If not, press			O.S.D.	: ON
			B.E.S.T.	: ON
	TV PROG. to place the
	°
	pointer next to “B.E.S.T.”,
	then press OK to set to		[TV PROG5°] =	:ON/OFF
	“ON”.
			[OSD] :EXIT
	CLOSE MODE SELECT
	SCREEN
4 Press OSD (		).
5	START RECORDING
	Press and hold RECORD and PLAY on the remote, or
	press RECORD on the recorder.

●The recorder spends approximately 7 seconds assessing the condition of the tape, then begins recording.

●"B.E.S.T." appears on screen and blinks when adjustment is complete.

Display Panel Indication [E639EE only]

As the tape check progresses, the “– –” marks on the display panel increase upward.