JVC HM-DH5U manual Cdg, Dear Customer

Page 2

2EN

Dear Customer,

Thank you for purchasing the JVC D-VHS video cassette recorder. Before use, please read the safety information and precautions contained in the following pages to ensure safe use of your new VCR.

CAUTIONS

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK.

DO NOT REMOVE COVER (OR BACK).

NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

WARNING:

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.

CAUTION:

This video cassette recorder should be used with AC 120VH, 60Hz only.

To prevent electric shocks and fire hazards, DO NOT use any other power source.

CAUTION:

TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

ATTENTION:

POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU'AU FOND.

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

NOTE:

Change or modifications not approved by the party responsible for compliance could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.

When the equipment is installed in a cabinet or a shelf, make sure that it has sufficient space on all sides to allow for ventilation (10 cm or more on both sides, on top and at the rear).

When discarding batteries, environmental problems must be considered and the local rules or laws governing the disposal of these batteries must be followed strictly.

VCR Plus+, C3 and PlusCode are registered trademarks of Gemstar Development Corporation.

The VCR Plus+ system is manufactured under license from Gemstar Development Corporation.

DSS™ is an official trademark of DIRECTV, Inc., a unit of GM Hughes Electronics. DISH Network™ is a trademark of Echostar Communications Corporation.

D-Theater is a technical specification based on D-VHS standards that was developed for HD content. Commercial D-Theater titles can only be played back on D-VHS digital recorders bearing the D-Theater logo.

DTS, DTS Digital Out are trademarks of Digital Theater Systems, Inc.

HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC.

CDG

LCassettes marked D-VHS, S-VHS and VHS can be used with this video cassette recorder. However, D-VHS recordings are possible only with cassettes marked D-VHS.

By using S-VHS ET it is possible to record and play back with S-VHS picture quality on VHS cassettes with this VCR.

LD-VHS is a new digital memory system that uses D-VHS tapes. D-VHS was developed as a memory system for multimedia applications that require storage for large volumes of information, such as for digital video.

LD-VHS tapes recorded on video products not using the D-VHS MTP/NTSC standard cannot be played back on this VCR.

LManufactured under license from Dolby Laboratories. Dolby, Pro Logic, and the double-D symbol are trademarks of Dolby Laboratories. Confidential unpublished works. Copyright 1992-1997 Dolby Laboratories. All rights reserved.

Page 1 Page 3
Image 2
Page 1 Page 3
Contents HM-DH5U CDG Dear CustomerInstallation Antenna Installation InstructionsServicing Before YOU Install Your NEW VCRUSE Do not block the VCR’s ventilation openings or holes About Head CleaningSymptoms of dirty video heads Do not expose the apparatus to dripping or splashingContents Front panel C E FRear panel VHF/UHFFront display panel AbcdPCM StereoStream AudioHow to use the Remote RemoteConnections 12 ENBasic Connection 14 EN Hdmi Connection Digital Set Top Box ConnectionBox Component Video Connection16 EN Plug & Play SettingPerform Plug & Play setup Auto Clock Set/Auto Tuner SetAccess Clock Set screen Clock SettingAccess Main Menu screen PreparationsSelect time zone Access Auto Clock Set screen Select D.S.T. mode18 EN Select host channelSetting clock manually Access Tuner Set Up screen Tuner SettingSetting channels automatically 20 ENAdd or skip desired channels Setting channels manuallyAccess Manual Channel Set screen Manual Channel Set22 EN Cable Box Control SettingInstalling Controller Turn on cable box Setting cable box input channel & brandAccess Cable Set Up screen Select cable box input channelEnter cable box brand Engage test mode24 EN Brand CodeHow to control the DBS receiver DBS Receiver Control SettingIf your DBS receiver has audio/video output connectors Connect DBS receiver to VCR26 EN Setting DBS receiver input channel & brandAccess DBS Receiver Set screen Turn on DBS receiverBrand Code Enter DBS Receiver’s brandPress FG to move the arrow to Brand JVC Dish Network Echostar Dish NetworkLoad a cassette Basic Playback28 EN Start playbackPlaying back tape repeatedly FeaturesChecking tape position You can play back a tape repeatedly 50 timesSelecting monitor sound Adjusting tracking condition30 EN Activate manual trackingSkipping unwanted portions Access distant codeAutomatic operations after rewinding Start searchAngle Selection 32 ENProgram Selection Subtitle SelectionTo resume normal playback, press Play Special Effect PlaybackLocating particular scene rapidly You can change the speed of picture searchViewing still picture frame by frame 34 ENViewing still picture Viewing slow motion pictureSet recording speed Basic RecordingLoad a D-VHS cassette Start recordingSelect recording channel 36 ENVHS/S-VHS/VHS Recording Changing display information Basic Recording FeaturesRecord X indicator starts flashing Specifying recording lengthShowing on-screen display 38 ENWatching one program while recording another Calibration S-VHS/VHS only a VHS Recording Mode aOther useful functions for recording Second Audio Recording a40 EN VCR Plus+ C3 Timer ProgrammingAccess VCR Plus+ screen Enter PlusCode numberCheck program data Return to normal screen Engage timer recording standby ModeTo use the VCR while it is in timer recording standby mode VCR Plus+ guide channel matching Changing VCR Plus+ C3 Setting42 EN Return to normal screen Input guide channel number Access Main Menu screen Input receiving channel numberAccess Guide Channel Set screen You have properlyExpress Timer Programming 44 ENTo timer-record daily or weekly serials 46 EN Canceling or changing program settingsChecking program settings Make sure the record safety tab is intact Set timer program on DBS receiverEngage Satellite Auto Recording Standby mode Satellite Auto RecordingEngage recording standby mode Link Timer ProgrammingSet timer program on the Inte- grated Hdtv source 48 ENVideo Remote Control Timer Programming Auto SP N EP Timer S-VHS/VHS only a Other Useful functions for timer recordingAuto Timer a 50 ENSelect program Access Video Navigation screenNavigation Playback Press Navi52 EN Access Video Navigation screenAccess Navigation Set Up screen Deactivating Video NavigationFinding Tapes Access Library screenAccess tape number list screen Finding by tape numberFinding by category 54 ENFinding by program title Confirm listsFinding by recording date 56 EN Finding blank spaceEditing Titles Editing tape titleEnter title Access edit screen58 EN Number KEY CharactersSelect program Entering or Editing program titleLoad a cassette Deleting tape information 60 ENEditing program category Delete program information Deleting program informationChecking memory Check memoryUseful Function Settings 62 ENVideo settings Video Function Mode Audio settings Audio Function64 EN 2ND Audio RECInput/Output settings IN/OUT Function Additional settings Additional 66 ENLink 68 EN Set to onSet Jlip ID Number Jlip ID Number SettingSelect Jlip ID Set Up screen Confirm Linc setting Link Set UpAccess i.LINK Set Up screen 70 ENLink Branched Connection What is i.LINK?Link Connection Link Connection ExamplesLINK/DV Connections 72 ENConnection with the camcorder Make connectionsSelect input location on this VCR Connection with the VCRVIDEO/VIDEO Connections 74 ENVHS HS, STD, LS3 Select video input terminalSet Picture Control to VHS/VHS SP, EPTV Brand Setting 76 ENEnter brand code Cable Box or DBS Receiver Brand SettingTurn on the cable box or DBS Receiver Operate cable box or DBS Receiver78 EN Changing Remote Control CodeSet remote control code for Remote Turn off VCRSymptom Possible Cause Corrective Action 80 EN VCRThere are no programs in memory Cable Set Up screen and selectBlinks on the front display Again82 EN Picture stops/There is no sound Playback of tapes recorded in D-VHS modeSearching images on D-VHS tapes Image or sound is distortedCode Message Description Error Codes and Messages84 EN INST.BOOK Video Signal is not Found forContent is not Acceptable This Program86 EN Questions and answersTimer Recording PlaybackHdcp GlossaryDTS Hdmi88 EN List of termsAccessories TimerConnectors General90 EN What YOU Must do for Warranty ServiceWhat is not Covered What WE will doMemo Remember to retain your Bill of Sale for Warranty Service Toll Free 1 800
Related manuals
Manual 92 pages 2.43 Kb
Top Page Image Contents