JVC HM-DH5U Changing Remote Control Code, 78 EN, Set remote control code for Remote, Turn off VCR

78 EN MULTI-BRAND REMOTE CONTROL (cont.)

Changing

Remote Control

Code

[POWER] [PLAY(I)]

A	CE
VCR CABLE
TV /DBS	B- A,C

B- B

B- C

NOTE:

When “POWER SAVE” is set to “ON”, you can not change the remote control code. Before changing the code, set “POWER SAVE” to “OFF” (A page 67).

The Remote is capable of controlling four JVC video recorders independently. Each of VCRs can respond to one of four codes (A, B, C or D).

This Remote control is preset to send A code signals because your VCR is initially set to respond to A code signals. You can easily change your Remote and the VCR to send and respond to B, C or D code signals.

When using four JVC VCRs, set the four VCRs and their Remotes to different codes, so that the Remotes can operate these VCRs separately.

ASet remote operation mode

Set the [VCR/TV/CABLE/DBS] selector to [VCR].

BSet remote control code for

Remote

APress and hold [A/B/C/D].

BPress the ‘Number’ key [1] for A code control signals, [2] for B code control signals, [3] for C code control signals and [4] for D code con-

trol signals.

CPress [STOP (L)], and release [A/B/C/D].

CTurn off VCR

Press [POWER] on the VCR.

DCheck remote control code for VCR

Press [PLAY (I)] on the VCR for more than 5 seconds.

•The code currently set appears on the front display panel.

ETurn on VCR

Press [POWER] on the Remote.

•The code transmitted from the Remote blinks for a few seconds on the front display panel.

•After the code disappears on the front display panel, make sure that the VCR is turned on by pressing [POWER] on the Remote.

To control four VCRs with the same Remote

You can control four JVC VCRs by switching the remote control code for the Remote between A,B, C and D as in step B , keeping four VCRs to different control codes.

•Press the ‘Number’ key [1] for A code control signals, [2] for B code control signals, [3] for C code control signals and [4] for D code control signals. (To change only the remote control code for the Remote, DO NOT perform steps C to E.)

(E.g.) To set Remote to B code:

A/B/C/D	STOP
	Release
	ABC
Hold	Press in succession
down