JVC BR-DV3000E Introduction Precautions on the use of cleaning tape, Cassette tape, Condensation

Page 6

INTRODUCTION Precautions on the use of cleaning tape

Condensation

Please use cleaning tape produced by JVC.

Please follow the instructions below when using the cleaning tape.

1. The tape will run for 10 seconds in the PLAY mode. (Thereafter, it stops automatically and enters the STOP mode.)

After loading the cleaning tape, press the PLAY button.

2. For a single cleaning session, use it up to 4 times.

3. Please refer to the following table as a guide for cleaning:

Memo:

1.Under low humidity conditions, (10% RH to 30% RH), please perform head cleaning at intervals of half of the following stated periods.

2.If M-DV80 is used immediately after cleaning, the VTR warning (“HEAD CLEANING REQUIRED!”) may disappear only after the tape has run for some time.

3.Please use the cleaning tape at room tempera- ture (10˚C to 35˚C).

4.Instructions for using the cleaning tape are stated inside its case. The contents may be slightly different from those stated here.

Please follow the instructions in this manual.

When this unit is moved from a cold to a warm

When condensation occurs, the monitor displays

 

place abruptly, the vapor in the warm air will come

 

the following warning:

 

into contact with the head drum or the tape

 

 

 

guides. When chilled, the vapor turns into drop-

 

 

 

lets of water. This state is known as condensa-

 

 

 

tion. When condensation occurs, the videotape

 

CONDENSATION ON DRUM

 

will adhere to the head drum or the tape guides

 

 

 

 

 

and will be damaged.

 

 

Condensation occurs on this unit in the following circumstances:

• It is moved abruptly from a cold place to a warm

 

To remedy, leave the unit with the power ON and

 

wait until the WARNING indicator disappears.

place.

 

 

 

• It is used in a room immediately after the heater

 

 

has been turned on, or when cold breeze from

Prevention of condensation

Operating environment

Low temperature

Room temperature

High temperature

of the unit

5˚C to 10˚C

10˚C to 35˚C

35˚C to 40˚C

Guide for using

1 to 2 times every

1 to 2 times every

1 to 2 times every

cleaning tape

5 hours

20 to 30 hours

5 hours

an air-conditioner blows onto it.

When transporting the BR-DV3000 from a cold

 

 

 

• It is used at a place of high humidity.

to a warmer place abruptly, first take out the cas-

 

 

Head drum

sette. Then place the BR-DV3000 in a plastic bag

 

 

 

and seal it before transporting the camera. Leave

 

 

 

the BR-DV3000 in the sealed plastic bag until

 

 

 

the camera has the same temperature as the sur-

 

 

 

roundings. This will prevent condensation.

Cassette tape

 

This unit can record onto and playback standard

DV and mini DV cassette tapes (for SP mode only).

Please use the following JVC cassettes with the

or the

logos.

 

Standard DV cassettes

Mini DV cassettes

LA-DV276

M-DV63PR0

LA-DV186

M-DV60

LA-DV124

M-DV30

Erasure prevention

DV cassettes have a safety slide at the back to prevent accidental erasure.

To prevent accidental erasure of important records, push the slide to the “SAVE” position.

To record, push the slide to the “REC” posi- tion.

Slide

 

 

Videotape

 

 

When a cassette tape is loaded, please do not

transport e.g., from an external cold place to a

warm room thereby subjecting the unit to dras-

tic temperature changes.

After moving the unit, please do not use it until

the innards are stabilized.

 

Memo

 

REC

 

 

DVCAM cassettes can be recorded in DV format.

 

 

SAVE

 

 

 

 

Tapes recorded in DVCAM format can be played

 

 

 

 

 

 

 

 

 

(SP Mode).

 

 

 

 

 

M-DV80 cassettes(Mini DV 80min tape) cannot be

 

 

 

 

 

 

used with this unit.

 

 

 

 

 

 

Precautions on the use of tape

 

 

 

 

 

Reverse sides of videotapes cannot be used.

 

 

 

 

 

Please store the tape only after it has been fully rewound, so as to avoid damaging the tape.

Please store the cassette in places low in humidity, well-ventilated and fungus-proof.

When a cassette is used repeatedly, noise may increase due to e.g., dropout, etc. hence affecting its

 

performance. Please do not use dirty or damaged tapes as they will shorten the life span of the

 

rotation head.

 

 

 

 

 

8

9

Image 6
Contents For service purpose with modified contents BR-DV3000UPort Cable LengthFor Your Safety Australia LA PluieImportant In the United Kingdom Table of Contents Precautions Daily maintenance and regular inspectionCassette tape Introduction Precautions on the use of cleaning tapePrecautions on the use of tape CondensationFront panel Play Play button/LED FF Fast forward button/LED Indicator Audio indicatorREC Record button/LED @ Stop Stop button/LEDRear panel REV button Still Mode buttonADV button Operate button fMemo  Display at position a Operation in progress  Display at position B Display for about 3 secondsRefer to For details, pleaseLoad in 2 batteries Close the cover Precautions on the use of battery Operable scope of the wireless remote controller Model onlyConnecting to the AC adapter PowerTurning off the power Switching on the power To set the unit to the Operation Lock mode Operation Lock modeSelecting the NTSC/PAL signal system  To turn off the Operation Lock modeSetting the date and time Ejecting the cassetteTo engage the Display 2/2 menu Enabling on-screen displayPlay the Display 1/2 menu Set the Date Style and Time Style itemsRecording Connection and setting SettingConnection Time code recording Setting time codesPreset time codes Recording time codes of a DV input terminalRecording index signals Recording methodRecording Audio dubbing Backup recording function Connection/setting Fast forward/rewind Basic playback methodSpecial playback function Frame advance reverse playbackVariable speed playback Special playbackLocate function Index searchRepeat operation  Repeat Mode item of the System 1/2 menuRepeat playback Ginning Press the Play button to begin replay Applicable model  Setting the TC Adjust item of the Time Code menuPlayback signals Panel to 9 PINPanel can be set at any position  The Remote SEL switch on the frontRemote FF/REW Mode Remote Set the unit to the Stop mode Display the menu for settingDisplay the TOP Menu Contents of the menus Contents of the menus Items Setting  Remote 2/2 menu32k  Display 1/2 menu  Display 2/2 menu Model Warning display Displayed regardless of the Display mode  AlarmTo return to the usual screen  To set the unit to the Stop modeRemote controller Main unit Press the Menu button Operate button is pressed Diagram of external dimension Unit mm 260