Magnavox MDV650R Connecting with a Component Video Y Pb Pr cable, Please note the color order

Connecting with a Component Video (Y Pb Pr) cable

Have the following cables ready:

an antenna cable (1 supplied), a power cable (2 supplied), a Component Video (Y PB PR) cable (3, red, green, blue jack) or a corresponding video-compatible cinch cable, an audio cable (4 supplied red/white jack).

1

2

3

Remove the antenna or cable TV signal from your TV. Connect it to the ANTENNA jack at the bck of the DVD recorder.

Insert one end of the supplied antena cable into the TV plug at the back of the DVD recorder and the other end into the antenna input jack at the back of the TV.

Use the Component Video (Y PB PR) cable and connect one end to the red, blue, green OUT COMPONENT VIDEO jacks at the back of the DVD recorder and the other end to the Component Video In jacks of the TV.

Please note the color order
The colors of the jacks on the DVD recorder must match those on the
TV (red-red/blue-blue/green-green). If they are not matched properly,
this could cause the color of the picture to be reversed or there could	Tip
be no picture at all.

4Use the supplied audio cable and plug one end into the OUT AUDIO LR jack at the back of the DVD Recorder (next to OUT COMPONENT VIDEO ) and the other into the red/white

Audio In jacks of the TV (usually called Audio in', 'AV in'. Please see your TV's owner's manual).

5Switch on the TV.

Set the TV to the Component Video channel

If necessary, see the operating instructions for your TV. Or, go to channel zero on your TV, then keep changing channels down until you see the DVD Recorder screens (when the Recorder is on). This is not channel 3 or 4 as it would be if you used only the cable/antenna connection.

22 Connecting the DVD recorder