Hitachi DV-RX5000U manual Changing the remote control code, Press Setup

Changing the remote control code

	DVD POWER TV			DVD	TV
	VCR Plus+ TV/VIDEO REC MODE				REC
Numbered	1	2		3
buttons
	4	5		6	CH
	7	8		9	VOLUME
	CANCEL
		0	100
	SKIP			SLOW/SEARCH
		A		E
	OP	P	US		PL	AY
	ST
	DIRECT NAVIGATOR				PLAY LIST
	TOP					MENU
3, 4, 2, 1	MENU
		ENTER
ENTER
	FUNCTIONS				RETURN
	PROG/CHECK	ADD/DLT	CM SKIP		TIME SLIP
	OPEN/CLOSE STATUS			FRAME
SETUP	SETUP	AUDIO	INPUT SELECT DISPLAY
	ERASE	F Rec	POSITION MEMORY MARKER

Hitachi DVD players and recorders use the same remote control system so they may respond unintentionally to a command from this remote control. Change the code on this unit and its remote control (the two must match) if you place equipment close together.

≥Use “1”, the factory set code, under normal circumstances.

1 While stopped

Press [SETUP] to show the menus.

SETUP
	Antenna System		CATV
	Auto Channel Setting
	Channel Caption
Channel
	Preset Channel Caption
Set Up
	Manual Channel Caption
Disc
Video	VCR Plus￿CH Setting
Audio
Display	TAB SELECT
TV Screen		RETURN

2 Press [3, 4] to select “Set Up” and press [1].

3 Press [3, 4] to select “Remote Con- trol Code” and press [ENTER].

4 Press [3, 4] to select the code (1, 2, or 3) and press [ENTER].

The remote control code on the unit has been set.

5 While pressing [ENTER] on the remote control, press the numbered button ([1], [2] or [3]) corresponding to the code you selected in step 4.

The remote control code on the remote control has been set.

6 Press [SETUP]

The following display appears when you use a remote control with a different code.

The unit’s remote control code

If you are trying to use this unit’s remote control, change its code to match the unit’s (➜ step 5).

Advanced operation

45