KitchenAid KHPS 9010, KHPF 9010 manual

Page 7

Warnings and suggestions

To get the most out of your hob, please read the instructions carefully and keep them for future consultation.

These instructions are only valid in the countries whose destination symbol is shown on the serial number plate on the hob.

The packing (plastic bags, expanded polyurethane, etc) pose a potential threat to children and should be disposed of carefully.

Check the appliance has not been damaged during transportation and remove all protective packing and films before installation.

This hob (cat. 3) was designed to be used exclusively for cooking food in household surroundings. Any other use (for example heating rooms) should be regarded as improper and dangerous.

The installation and connection of this appliance to a gas or electrical supply must be carried out by a competant, qualified person in compliance with current legislation.

This appliance should be installed in compliance with standards in force and only used in well ventilated rooms. Read the instructions before installing and using this appliance.

The pre-fitted gas connector and it's supply pressure are shown on the label attached to the bottom of the hob. If this type of gas supply is not being used, please refer to the section called Adaption to different types of gas supply on page 11.

Note:

Incorrect placement of the pan supports can scratch the hob. To avoid this always ensure that the rubber feet on the bottom of the pan supports are the only part of the pan supports that touch the hob and do not drag the pan supports accross the hob surface.

On the glass surface do not use:

-Cast iron grills, terracotta pots or pans.

-Heat convectors (e.g. metal netting).

-Using two burners to cook 1 pan.

In the event of prolonged usage, additional ventilation may be required (opening a window or increasing the extration speed of the hood).

Warning

Keep children away from the hob when in use and don't let them play with the control knobs or any other part of the appliance.

Do not let children play with the pan supports. The rubber feet on the underneath of the pan supports could be swallowed by small and cause serious injury or suffocation.

Before replacing the pan supports on the hob, please check that all the rubber feet are in place.

Each time you finish using the hob, always check that the control buttons are in the off position and shut off the tap to the gas mains or cylinder.

Do not obstruct the air vents at the back of the appliance in any way.

7

Image 7
Contents Khpf 9010 Khps Page Page To turn on one of the burners Product description and symbolsUsing the burners Control SymbolsPositioning the pan supports and wok support Practical advice on using the hobYou should never use Injector table Hood and cabinetry clearances mmPage Packing Safeguarding the environmentProduct Gas connection Installation Flush and Traditional fittingTechnical information for the installer Before installation, please ensure thatFixing the hob to the work top. Traditionally fitted model Electrical connectionBe carried out by competent technical Important The following procedure mustDimensions shown in the diagram Fixing the hob to the work top. Flush fitted modelWok Burner W Adaption to a different type of gas supplyReplacing the injectors Traditional burners TRegulating the minimum flow level of the gas taps Fitting the wok burnerCare and maintenance of the gas burners General cleaning & maintenancePans are not stable? Check that Troubleshooting guideAfter Sales Service Flame doesn’t stay on? Check that5019 719