KitchenAid KHPS 9010, KHPF 9010 manual Fixing the hob to the work top. Flush fitted model

Page 11

Fixing the hob to the work top. Flush fitted model

Important: The following procedure must

860

 

be carried out by competent technical

510

 

personnel only. The hob can be installed

 

on, or into different types of materials,

80

 

such as masonry, metal, wood and heat

861

 

848

 

resistant laminate coated wood (90°C).

 

 

 

Cut an opening in the worktop to the

498

511

dimensions shown in the diagram.

R.11

 

 

 

Note: For laminated worktops with a laminate

thickness of less than 3 mm, create a recess as shown as on the detailed schematic drawing.

Before positioning the hob, apply the adhesive gasket/seal supplied, on the underneath edge of the hob itself, where the hob will be in contact with the worktop (fig. 2).

Once the seal is in place, place the hob into the recess. Secure the hob into the work surface using the screws and brackets provided, tightening them until the hob is perfectly flush (fig. 3).

Carefully trim off the excess gasket/seal. In case of installation on wood (particularly chipboard), any small spaces between the edge of the worktop and the hob should be filled with small quantities of silicon sealant (see fig. 4). Once the appliance has been installed, the bottom of the hob should be completely accessible.

Important:

tighten the fixing brackets of the hob to the work top by hand, using minimum force.

In case of wooden (or similar) worktops, before fitting the adhesive seal protect the surface of the milled recess with a primer.

Slots for extra brackets have been created on the bottom of the appliance, to help achieve a more flush positioning (should this be necessary). Appropriate brackets can be obtained from the Customer Care Centre.

1,2

2,2

 

Fig. 1

Fig. 2

Fig. 3

Fig. 4

11

Image 11
Contents Khpf 9010 Khps Page Page To turn on one of the burners Product description and symbolsUsing the burners Control SymbolsYou should never use Practical advice on using the hobPositioning the pan supports and wok support Injector table Hood and cabinetry clearances mmPage Product Safeguarding the environmentPacking Gas connection Installation Flush and Traditional fittingTechnical information for the installer Before installation, please ensure thatFixing the hob to the work top. Traditionally fitted model Electrical connectionBe carried out by competent technical Important The following procedure mustDimensions shown in the diagram Fixing the hob to the work top. Flush fitted modelWok Burner W Adaption to a different type of gas supplyReplacing the injectors Traditional burners TRegulating the minimum flow level of the gas taps Fitting the wok burnerCare and maintenance of the gas burners General cleaning & maintenancePans are not stable? Check that Troubleshooting guideAfter Sales Service Flame doesn’t stay on? Check that5019 719