Kenwood DM-9090 instruction manual Synchro recording with CD playback, Digital recording and Scms

Page 30

Recording (DIGITAL input)

DM-9090 (En)

30Synchro recording with CD playback

By connecting this unit with a KENWOOD “ ” type amplifier and CD player, which are equipped with system control jacks, using system control cords, the recording of MD can be started in synchronism with the playback of the CD player.

1Set the amplifier’s input selector to CD.

2 Put the CD player in pause mode.

3 Select the CD track to be recorded using the 4 or ¢ key. 4 Put the MD recorder in record-pause mode.

5 Start playback of the CD player.

To stop recording

Press the 7 key, then press the 0 key.

DIGITAL recording and SCMS

Note that the digital recording of Mini Discs is not possible in the following cases.

If the digital source has a copy prohibition code, “001 SCMS ON” is displayed and the unit enters record-pause mode. (This message is displayed when copy prohibition is encountered during recording of track number “001”.)

Note on the sampling rate converter

Three types of digital signals are usually used according to the sampling frequencies. The sampling frequencies vary depending on the types of digital equipment as shown below.

48 kHz

: Standard mode of DAT, B mode broadcasting of BS tuner, etc.

44.1 kHz

: Standard mode of DAT, CD, MD, etc.

32 kHz

: Standard and long-hour modes of DAT, A mode broadcasting of BS tuner, etc.

In general, high-quality recording based on digital signal transmission is available only when the sampling frequency of the source equipment matches that of the recorder equipment. However, this unit incorporates a sampling rate converter so that it can also record digital signals sampled at 48 kHz and 32 kHz by converting their sampling frequency into the sampling frequency of MD (44.1 kHz).

The SCMS may be activated with certain type of satellite broadcasting.

(DAT: Digital Audio Tape deck)

SCMS (Serial Copy Management System)

Designed for copyright protection, the SCMS is a pre- scription that copying of digital signals as they are in the digital form between digital audio equipment is allowable only for one generation.

Copy using digital

Copy using digital

 

input

 

 

input

Digital copy can-

 

 

not be repeated.

Copy using analog input

Copy using analog input

Copy using analog

inputCopy using digital input

Copy using digital input

Faded recording of MD

The fade mode of the unit is switched on/off every time the FADE key is pressed.

Recording with fade-in:

When recording is initiated during stop (or pause) in the fade mode, recording starts from ATT = - `, increases to the previously set recording level and continues at this level.

Recording with fade-out:

When recording is stopped during recording in the fade mode, the current recording level decreases to ATT = - ` then recording stops.

If recording is continued until the end of disc, fade-out occurs automatically before the unit stops recording.

Fade-in and fade-out

Fade-out : Ending of music after gradual decrease in volume.

Fade-in : Beginning of music after gradual increase in volume.

Gradual sound

Gradual sound

decrease

increase

1st track

2nd track

Fade-out Fade-in

Page 29 Page 31
Image 30
Page 29 Page 31
Contents DM-9090 Units are designed for operation as follows Introduction Before applying powerSafety precautions Factory fitted moulded mains plugContents Special feature AccessoriesImportant Safeguards Power OFF Information that you should know Safety Precautions Handling of Mini DiscInstallation position Dust countermeasureReference notes Beware of condensation Maintenance CleaningMemory backup Be especially careful in the following conditionsMD system System connections Digital input / output jacks OpticalAbout the system control connections About the system control operationsNames and functions of parts Listening through headphonesStandby mode Display / Main unitDescription of main unit keys Remote control unit Model RC-M0702 Infrared ray systemOperation Operation of remote control unitLoading batteries 1Remove the cover.2Insert batteries.3Close the coverPlaying tracks in order from track No Disc recorded in monaural modePlayback of Mini Disc Before playing a MDSelect the desired title PreparationPress the Title Search key T L ERandom playback 1Enter the track modeEnter the track mode Select the desired track numberTo pause playback Skipping tracksSearching in a track To stop playbackProgramming tracks in a desired order Initiate the program modeProgramming Select track numbers in the order you want to play themTo clear tracks from the program To add a track to the programChecking the order of tracks Clearing tracks from the endTo stop repeated playback Repeated playbackTo repeat only the programmed tracks To repeat the entire discRecording-related keys AUTO/MANUAL key Monitor keySelect before starting recording REC LEVEL? REC Mode keySelecting the setting adjustment mode Auto TIME?When Auto LEVEL? is displayed When D.REC LEVEL? is selectedWhen Auto TIME? is displayed When Fade TIME? is displayedAnalog recording 1Adjust the settings if requiredRecording Analog input Select Analog or MonoStart recording Adjust the recording level. Main unit onlySelect Auto or Manual After recording, eject the Mini DiscSelect one of Digital 1, 2 Recording Digital inputDigital recording To fade in and fade out the musicAdjust the digital source recording level UnlockTrack being played Track Erase Synchro recording with CD playback Digital recording and ScmsReordering tracks by moving them EditingSelecting the editing function type Erasing desired tracks Quick EraseV E Moving the track being played Track MoveSelect Move Select the move destinationExecute the track reordering operation To cancel the editing results Edit CancelImage of track moving Eject the Mini Disc2Select the track numbers to be moved Moving several tracks at a time Quick Move1Select Q.MOVE End the selection of the track numbers to be moved2 / Ç? Image of track insertionP Ç? / 0 0 8 / Ç? E2Preview the result Dividing the track being played Track DivideSelect Divide V I D E +Image of preview Execute the track divide operationImage of track division 5 + 5 +2Select the track to be combined Combined tracks are decreased automaticallyImage of track combination Execute the track combine operationA S E Erasing the track being played Track EraseSelect Erase Confirm that the track has been erasedImage of track erasure 2To erase desired tracks 1To erase all MD tracksR a S E 5 ? a B CImage of track deleting Quick Erase When Disc Error is displayedS C Error Erasing desired tracksTotal number of title characters About preset titlesEditing titles Characters usable in title editingInput the title L ML M 3To change or erase a title N E O O D a B CN W O O D Execute title change or deletion Title editing function keysScrolling the display S C1Transmit the CD text into the MD recorder CD text editingCopying the CD text Single C D t e x tTime Display key Changing the displayed contentsThis key allows to switch the mode of time display Fade keyTimer operations Timer playback, timer recordingSymptom Cause Operation to resetSymptoms related to MD standard Case of difficultyDisplayed Message Meaning Action Other symptoms Symptom Cause RemedySpecifications Memo For your records
Top Page Image Contents