LG Electronics LST-3410A owner manual Connection Panel

Connection Panel

ANT IN

Connect to over-the-air outdoor/indoor antenna.

G-LINK

Gemstar cable box control connector. Connect G-LINK cable (supplied with your set-top box) to make timed recordings using the TV Guide On Screen™ feature.

Note: If there is a “demo pin” in the jack, remove it to disable demo mode.

AUDIO/VIDEO INPUT 1, 2

Connect audio/video output of an external source (Audio system, TV/Monitor,

VCR, Camcorder).

VIDEO OUT 1, 2

Connect to TV with composite video inputs.

COMPONENT OUTPUT

Connect to TV with YPbPr input.

DIGITAL AUDIO OUT (OPTICAL)

Connect to digital (optical) audio equipment.

AUTHORIZED SERVICE ONLY

Is used only for authorized service purposes.

DVI OUT

Connect to TV with DVI connection.

					AC Power Cord
					Plug into the power source.
					IEEE-1394
					Connect to IEEE-1394 equipment.
			RGB OUT
			Connect to TV with RGB input.
		Variable “volume” AUDIO OUT (Left/Right)
		Connect to a TV, amplifier, receiver or stereo system.
		You can adjust the volume of this audio out on HD DVR.
	Fixed “volume” AUDIO OUT (Left/Right)
	Connect to a TV, amplifier, receiver or stereo system.
	You cannot adjust the volume of this audio out on HD DVR.
S-VIDEO OUT				Do not touch the inner pins of the
Connect to TV with S-Video input.
				jacks on the rear panel.

	Electrostatic discharge may cause
CABLE IN
	permanent damage to the unit.
Connect to cable TV (CATV) signal source.

INTRODUCTION

9