Component Video Connection, Hdmi connection

DTBC-MNF(or D)1NP-AG 2007.9.20 2:57 PM ˘ ` 18

Connections

S-Video Connection

1Connect the S-VIDEO OUT jack on the DVB-T VCR/DVD Recorder to the S-Video in jack on your TV using an S-Video cable (S).

2Connect the Left and Right AUDIO OUT jacks from the DVB-T VCR/DVD Recorder to the left/right audio in jacks on your TV using the audio cables.

Component Video Connection

•If your television is a high-definition or ‘digital ready‘ television, you may take advantage of the DVB-T VCR/DVD Recorder’s Progressive Scan output for the highest video resolution possible.

•If your TV does not accept the Progressive Scan format, the picture will appear scrambled.

1Connect the COMPONENT VIDEO OUT jacks on the DVB-T VCR/DVD Recorder to the corresponding jacks on your TV using a Y Pb Pr cable (C) if the component (Y, Pb, Pr) is available on your TV.

2Connect the Left and Right AUDIO OUT jacks of the DVB-T VCR/DVD Recorder to the left/right audio jacks on your TV using the audio cables.

• When you use component video connection, you can change the resolution (576i, 576p) for the component output by setting the video output option in the setup menu (See page 31).

-Interlaced mode : 576i

-Progressive mode : 576p

•When you use the HDMI connection, the audio’s sampling frequency is outputted only with 48KHz even if you select [96KHz].

•This recorder does not perform internal (2 channel) decoding of a DTS sound track. To enjoy DTS multi channel surround sound, you must connect this recorder to a DTS compatible receiver via one of this recorder’s digital audio outputs.

•No sound will be output from the HDMI cable if the Digital out option is not set to ‘PCM’ on the Setup menu (See page 31).

•The arrow on the cable connector body should face up for correct alignment with the connector on the recorder.

•If there is noise or lines on the screen, please check the HDMI cable.

•When you use HDMI connection, you can change the resolution (576i, 576p, 720p, 1080i) for the HDMI output by setting the video output option in the setup menu (See page 31).

-RGB : 576i

-Interlaced mode : 576i, 1080i

-Progressive mode : 576p, 720p

•Changing the Progressive Scan mode when the recorder is connected with HDMI connector may result in malfunctions. To solve the problem, turn off the recorder and then turn it on again.

•Progressive Scan does not work with the RF, Audio/Video or S-Video connections.

HDMI connection

If you have a HDMI TV or monitor, you can connect it to this recorder using a HDMI cable.

1Connect the HDMI jack on the recorder to the HDMI jack on a HDMI compatible TV or monitor

(H).

2Set the TV’s source to HDMI (refer to TV’s Owner’s manual).