LG Electronics MZ-42PZ42V, MT-42PZ42S Screen Menu Options, Auto Adjustment RGB1 PC mode only

Screen Menu Options

Auto Adjustment (RGB1 (PC) mode only)

-Automatically adjusts picture position and minimizes image shaking.

-Although the image is still not correct, your Monitor is functioning properly but needs further adjustment.

1.Press the AUTO CONFIG. button to run Auto configure.

• If the position of the image is still not correct, try Auto adjustment again.

2.If picture needs to be adjusted more after Auto adjustment in RGB1 mode, you can manually adjust the image position and Phase.

Adjusting Horizontal/ Vertical Position

-You can only adjust V-Position/H-Positionin COMPONENT (480p) or RGB1(PC).

1.Press the MENU button and then use D / E button to select the SCREEN menu.

2.Press the G button and then use D / E button to select Screen adj..

3.Press the G button and then use D / E button to select V-Positionor H-Position.

4.Press the G button and then use the F / G button to adjust until you get desired hori- zontal or vertical position.

•The adjustment range of V-Positionis -50~+50.

•The adjustment range of H-Positionis -100~+100.

•If you install the monitor vertically on the wall, the adjustment range of V-Position/H- Position may change.

•Based on the PC resolution, the adjustment range of V-Position/H-Positionmay change.

•Based on input signal, the position of the picture may not change even though you have adjusted the horizontal or vertical position with this function.

5.Press the MENU button.

Screen

Screen adj.	G	To Set
VGA Mode
ARC
PIP/DW
Zoom

Screen adj.

Auto configure
	[V-Position]	G	0
	[H-Position]
Phase
Reset

Picture Phase Adjustments (RGB1 (PC) mode only)

-If the picture isn’t clear after auto adjustment and especially if characters are still jittery, adjust the picture phase manually.

1.Press the MENU button and then use D / E button to select the SCREEN menu.

2.	Press the G button and then use D / E button to select Screen adj..	Screen adj.
			Auto configure
3.	Press the G button and then use D / E button to select Phase.			[V-Position]
				[H-Position]
			Phase		G
4.	Press the G button and then use the F / G button to adjust phase.		Reset

• The adjustment range of Phase is 0 ~ 63.

5.Press the MENU button.

30

19