APPENDIX
APPENDIX
PROGRAMMING THE REMOTE CONTROL
The provided universal remote control can be programmed to operate most
Programming a code into a remote mode
1To find out whether your remote control can operate each device without programming, turn on the device (such as a VCR) and press the corresponding mode button on the remote.
After that, press the POWER button. If the device is turned off and it responds properly the remote control need not be programmed. If not, the remote should be programmed to operate the device. The program- ming procedures are explained below.
2Press the MENU and MUTE button continuously at the same time for two seconds; the currently selected device button is illuminated.
If you don't press any button for 20 seconds, the light on the mode button will be turned off. In that case, you have to repeat from step 2.
3Enter the appropriate code from the code table on the following pages. When pressing the button, the light blinks at a time. If the device turned off, the programming is successful.
4Press the MENU button to store the code. After blinking twice, this code is stored.
5Test the remote control functions to see if the device responds properly. If not, steps
PROGRAMMING CODES
DVD
Brand | Codes |
| Brand | Codes | Brand | Codes | |||
|
|
|
|
|
|
|
|
|
|
APEX DIGITAL | 022 |
|
| MITSUBISHI | 002 |
| RCA | 005 | 006 |
DENON | 020 | 014 |
| NAD | 023 |
| SAMSUNG | 011 | 015 |
GE | 005 | 006 | ONKYO | 008 | 017 | SONY | 007 |
| |
HARMAN KARDON |
| 027 |
| PANASONIC | 003 | 009 | THOMPSON | 005 | 006 |
JVC | 012 |
|
| PHILIPS | 013 |
| TOSHIBA | 019 | 008 |
LG | 001 | 010 | 016 025 | PIONEER | 004 | 026 | YAMAHA | 009 | 018 |
MAGNAVOX | 013 |
|
| PROCEED | 021 |
| ZENITH | 010 | 016 025 |
MARANTZ | 024 |
|
| PROSCAN | 005 | 006 |
|
|
|
|
|
|
|
|
|
|
|
|
|
84