Beko 15LB250MID operating instructions Connection of mains Cable, Electrical Connections

Page 8

22) Connection of mains Cable

Always use the mains cable supplied. First of all insert the mains cable into the input panel of the CTV, and only there after into the mains supply socket.

23) ELECTRICAL CONNECTIONS

For your own safety read the following instructions carefully before attempting to replace the moulded mains plug. Please check the type of mains lead supplied with your television and refer to the appropriate information below.

 

IMPORTANT

As the colours in the mains lead of this

 

 

 

appliance may not correspond with

 

The wires in the mains lead are coloured

the coloured markings identifying the

 

in accordance with the following code:

terminals in your plug, proceed

 

Blue - Neutral

 

as follows:

 

Brown - Live

 

The wire which is coloured blue or

 

 

 

black must be connected to the

 

 

 

terminal which is marked with the

 

 

5 A

letter N or coloured black.

 

 

The wire which is coloured brown or red must be

 

 

 

connected to the terminal which is marked with the letter

 

 

 

L or coloured Red.

 

 

 

No connection is to be made to the Earth terminal of the

 

 

 

plug.

 

 

 

If a 13 Amp (BS1363) Plug is used, fit an ASTA

 

 

 

apporoved 5 A fuse

 

 

 

If your product is fitted with a moulded plug which

 

BLUE

 

requires replacement please cut off and dispose of it

 

(Neutral)

 

safely, then rewire as shown in the diagram to the left.

 

 

 

 

 

 

 

IMPORTANT

As the colours in the mains lead of this

 

 

 

appliance may not correspond with the coloured

 

The wires in the mains lead are coloured

markings identifying the terminals in your plug,

 

in accordance with the following code:

proceed as follows:

 

Blue - Neutral

 

The wire which is coloured green and yellow must

 

Brown - Live

 

be connected to the terminal which is marked with

 

Yellow/Green - Earth

the letter E, or by the earth symbol, or coloured

 

 

 

green or green and yellow.

 

 

5 A

The wire which is coloured blue or black must be

 

 

connected to the terminal which is marked with the

 

 

 

letter N or coloured Black.

 

 

 

The wire which is coloured brown or red must be

 

 

 

connected to the terminal which is marked with the

 

 

 

letter L or coloured Red.

 

 

 

If a 13 Amp (BS1363) Plug is used fit an ASTA

 

 

 

approved 5 Amp fuse.

 

 

 

If your product is fitted with a moulded plug which

 

 

 

requires replacement please cut off and dispose of it

 

 

 

safely, then rewire as shown in the diagram to the left.

 

 

 

24)

Cover a table with a soft towel (or other protection to prevent damage to the TV or table)

Carefully lay the T.V. front down on the table

 

 

position the T.V. table stand so that it hangs over the edge of the table

 

Remove the screws that hold the stand to the T.V.

Remove the stand.

Attach any new brackets before lifting T.V. back up.

Note: Keep removed stand and screws safely for future use.

6

Image 8
Contents 15LB250MID Operating Instructions Table of Contents Cleaning the screen and cabinet Disposing of your TV at the end of service lifeSuperior features of your integrated digital television Important InformationFeatures of your new television Special Features TV for the first time Important Safety Instructions Power connections Product, then it must be connected to an earthed socket Never operate yourCause permanent loss of hearing Batteries. There is the risk of explosion Connection of mains Cable Electrical ConnectionsPowering on your device and the initial use StartAerial connection BatteriesYour new television TV Control PanelExternal Connections External Connections TableRemote Control Digital Mode OnlyPerforming the initial power-on settings TV controlsTurning on the TV and Setting the Channels Performing Digital TuningsAutomatic Tuning of Channels and Storing in the Memory Manual tuning of channels and storing in the memoryProgram Table Electronic TV Guide EPG Digital FeaturesCreating favorite channels list Performing Analogue Tunings Setup System Channel Fine Tuning Switching the locations of the stored channelsIf you do not know the channel number Deleting a stored channelPicture Menu Settings Settings on your new televisionSound Menu Settings Features Menu Settings Teletext Question Answer Button Reveal ClockFastext Toptext optionalConnection types for external devices PC ModeExternal equipment connection Help and tips Technical specifications chart Remote control does not functionSymptoms SolutionMain UK Transmitter Stations Guarantee Television What is covered?HOW to Obtain Service Please complete the box below for ease of reference laterFAU.801