Beko 15LB250MID Start, Aerial connection, Powering on your device and the initial use, Batteries

Page 9

4Start

Remove your television carefully from its box. You can keep the packaging of your television to use in future.

Items supplied with your television

Mains lead (*) Adaptor (*) Remote control 2 batteries

Note: The Scart, VGA (*) and PHONO cables are not supplied with the device.

(*)These features are optional and may not be available on all models.

4.1-Aerial connection

If you use a 75 Ohm coaxial cable (round cable) as an aerial cable, connect the aerial plug directly to the aerial input located on the TV.

Motorized vehicles, energy lines and telecommunication lines affect your aerial. Therefore, be careful to install your aerial away from these and metal surface in such a way that it shall not move. Do not make your aerial cable longer than required and do not coil it. Make sure that it is not crimped passing through a window or door. Your aerial and cable might be affected by natural phenomena such as rain, wind, smoke and humidity over time. Periodically check your aerial and equipment.

4.2-Powering on your device and the initial use

1.Insert the mains lead or the adaptor into the appropriate power supply input located on the back panel of the LCD TV.

2.Insert the plug of the mains lead or adaptor, supplied with the TV into the mains socket.

Note 1: Your TV will switch to the stand-bymode in five minutes if there is no broadcast signal from aerial.

3.To power on your television, press any numerical key or P+ or P- keys on the remote control.

Note: If you are not going to use your television for a long time, unplug its power cable from the socket.

Initial power on and performing settings

To set up your television, read the sections on the TV controls and making the channel settings.

4.3-Batteries

Open the lid of the battery compartment and make sure that you have placed the batteries in the correct direction. For this remote control, UM-4, IEC R03 or AAA 1.5 V batteries are suitable.

Do not throw your old batteries into the fire, discard them in a dedicated waste area for this purpose.

Do not mix used batteries with new ones or different types of batteries together.

The performance of the remote control will be reduced at a distance of 8 meters from or at an angle of 30 degrees beyond the centre of the TV.

7

Image 9
Contents 15LB250MID Operating Instructions Table of Contents Disposing of your TV at the end of service life Cleaning the screen and cabinetSuperior features of your integrated digital television Important InformationSpecial Features Features of your new televisionImportant Safety Instructions Power connectionsTV for the first time Never operate your Cause permanent loss of hearingProduct, then it must be connected to an earthed socket Batteries. There is the risk of explosion Electrical Connections Connection of mains CableStart Powering on your device and the initial useAerial connection BatteriesTV Control Panel Your new televisionExternal Connections External Connections TableDigital Mode Only Remote ControlTV controls Performing the initial power-on settingsPerforming Digital Tunings Turning on the TV and Setting the ChannelsAutomatic Tuning of Channels and Storing in the Memory Manual tuning of channels and storing in the memoryProgram Table Digital Features Creating favorite channels listElectronic TV Guide EPG Performing Analogue Tunings Setup System Channel Switching the locations of the stored channels Fine TuningIf you do not know the channel number Deleting a stored channelSettings on your new television Sound Menu SettingsPicture Menu Settings Features Menu Settings Teletext Clock Question Answer Button RevealFastext Toptext optionalPC Mode External equipment connectionConnection types for external devices Help and tips Remote control does not function Technical specifications chartSymptoms SolutionMain UK Transmitter Stations What is covered? Guarantee TelevisionPlease complete the box below for ease of reference later HOW to Obtain ServiceFAU.801