Heath Zenith 598-1304-01 manual Features, Remote Control, Operation, Battery Replacement

Remote Controlled Products

Features

•Quickly add ON/OFF control of a receptacle without the expense of new wiring.

•Four selectable channels allowing the use of up to four separate systems in the same home.

•Products are UL/cUL and/or FCC/IC tested and approved.

•Operational range of up to 50 feet.

This manual applies to the following products:

OUTDOOR
ON
OF	F

INDOOR
ON
OF	F

Remote Control Indoor/Outdoor Receiver Indoor Plug-In Receiver

Remote Control

Operation

				1. The remote control will operate one
		INDOOR		or more receiver units with match-
OUTDOOR		ON		ing channels. There are separate
ON				ON / OFF buttons for the outdoor
	F	OF	F
OF				and indoor receiver.

Note: Receivers must be at least 10 feet apart for best performance.

2.Push the outdoor or indoor ON button to turn the desired plugged in receiver on. Push the outdoor or indoor OFF button to turn the

desired plugged in receiver off.

Philips-Head	Remote
	Control Back
Screw

Flat-Head

Screwdriver

Removing Back of Remote Control

Battery Replacement

The remote control requires a type A23 12 Volt alkaline battery to operate.The remote control is shipped with the battery installed.With typical use, the battery will last approximately one year.

To replace the battery, follow the instructions below:

1.Place remote control face down on a flat surface.

2.Remove screw on bottom of remote with a small phillips-head screwdriver.

3.Gently insert a small flat-head screwdriver between the two halves on the bottom of the remote and twist.Carefully separate the back of the remote from the front.

4.Lift the back of the remote up and lay aside.

5.Remove battery. Install replacement battery. Make sure battery is oriented properly (see illustration).

6.Reassemble remote in reverse order.

	Battery
ON	Compartment
1 2	(Type A23)

12 V

Inside of Remote Control

© 2007 HeathCo LLC 598-1304-01