Sim2 Multimedia HTL40 installation manual Switching on and OFF from Stand by

Table 2

		����������������	���������
������		���������
		��������� ��������	��������
���
��������������
�������
��
�����������������������
�������			�
�����			�
�����	����	����������	� ���������������

If the “No optical link” or “Error” signals are active the system will not function; if the “Warning” signal is active the system will operate but it may be unable to read certain input signals correctly.

SWITCHING ON AND OFF FROM STAND BY

Switching on the system (Fig.17):

•from the remote control (keys 0-9 )

•from the screen keypad (keys ▲ and ▼).

Typically, the picture will appear after 15-20 seconds.

0

LIG	RC	I	AUTO
HT		2005

??

?

�������

Switching off the system (Fig.18):

•from the remote control (key )

•from the screen keypad (key ).

LIG	RC	I	AUTO
HT		2005

??

?

Fig.18

If you wish to power off the two units completely, wait at least one minute in stand-by to allow the units to cool before setting the mains power switches to the “O” position or unplugging the power supply cables.

If power is disconnected from the Screen unit (e.g. setting the mains power switch to the “O” position or inadvertently unplugging the power cable), to restart the HTL40 LINK system also power-off the DigiOptic™ Image Processor unit and repeat the power-up sequence described at points 1 and 5.

If the fibre optic link between the two units is interrupted (e.g. by removing one or more cables) to restore normal system operation switch off the two units by means of the mains power switches, restore the fibre optic connections, and then repeat power-up mode steps 1 and 5.

Fig.17

Pressing a key from 1-9 on the remote control selects the corre- sponding input; pressing 0 selects the input that was active at the time the system was last switched off.

19