OSD TIMEOUT
Determines the On Screen Display timeout. When the On Screen Display appears it will remain displayed for the time set in this parameter starting from the time the last key was pressed. The
adjustment is made using the ◀ (decrease) and ▶(increase) keys within a
OSD POSITION
Serves to position the On Screen Display within the screen area. The OSD can be positioned using the arrow keys for fine adjust- ments or keys 1...9 on the remote control to select one of 9 preset positions.
MEMORIES
The main picture parameters can be saved in discrete sets of values called “Memories” so that they can be subsequently applied as a group using a single command.
3 separate Memories (Memory 1, Memory 2, Memory 3) are avai- lable for each of the 25 types of signals:
����������
����������
������������ ��
������������
������������������������������������������������
������������������������������������������������
������������������������������������������������
������������������������������������
������������������������������������������������
�����������������������������������
������������������������������������������������
������������������������������������
����������������
�����������������
�������������������
������������������ � ���
��������
for a total of 75 memories.
The image parameters that can be stored/retrieved by the Memories management system are as follows:
Image | Picture |
BRIGHTNESS | ASPECT |
CONTRAST | COLOUR TEMPERATURE |
�������
COLOUR | OVERSCAN |
TINT | GAMMA |
SHARPNESS |
|
FILTER |
|
SHARPNESS MODE |
|
VIDEO TYPE |
|
NOISE REDUCTION |
|
Some of these parameters may not be available for certain inputs or certain input signals, in accordance with the definitions in Tables 3 and 4.
Pressing the key on the remote control or the ◀ key on the keypad (Fig.27) serves to activate the menus management menu page.
LIG RCI | AUTO |
HT 2005 |
|
??
?
Fig.27
The available operations for each selected memory are described below.
SAVING A MEMORY
To save the image parameter current values in memory 1, move the cursor to line ‘1’ with the ▲ and ▼ keys and open the
��������
���������
������������ ����������������������
������������� ����������������������
��������������������
Fig.28
27