Unisen LT-46151, LT-52153, LT-40153, LT-46249, LT-40151, LT-52249, LT-52151, LT-46153 manual No Warranty

Page 91

Trademark and License Information

91

GNU General Public License, continued

a)Accompany it with the complete corresponding machine-readable source code, which must be distributed under the terms of Sections 1 and 2 above on a medium customarily used for software interchange; or,

b)Accompany it with a written offer, valid for at least three years, to give any third party, for a charge no more than your cost of physically performing source distribution, a complete machine-readable copy of the corresponding source code, to be distributed under the terms of Sections 1 and 2 above on a medium customarily used for software interchange; or,

c)Accompany it with the information you received as to the offer to distribute corresponding source code. (This alternative is allowed only for noncommercial distribution and only if you received the program in object code or executable form with such an offer, in accord with Subsection b above.)

The source code for a work means the preferred form of the work for making modifications to it. For an executable work, complete source code means all the source code for all modules it contains, plus any associated interface definition files, plus the scripts used to control compilation and installation of the execut- able. However, as a special exception, the source code distributed need not include anything that is normally distributed (in either source or binary form) with the major components (compiler, kernel, and so on) of the operating system on which the executable runs, unless that component itself accompanies the executable.

If distribution of executable or object code is made by offering access to copy from a designated place, then offering equivalent access to copy the source code from the same place counts as distribution of the source code, even though third parties are not compelled to copy the source along with the object code.

4.You may not copy, modify, sublicense, or distribute the Program except as expressly provided under this License. Any attempt otherwise to copy, modify, sublicense or distribute the Program is void, and will automatically terminate your rights under this License. However, parties who have received copies, or rights, from you under this License will not have their licenses terminated so long as such parties remain in full compliance.

5.You are not required to accept this License, since you have not signed it. However, nothing else grants you permission to modify or distribute the Program

or its derivative works. These actions are prohibited by law if you do not accept this License. Therefore, by modifying or distributing the Program (or any work based on the Program), you indicate your acceptance of this License to do so, and all its terms and conditions for copying, distributing or modifying the Program or works based on it.

6.Each time you redistribute the Program (or any work based on the Program), the recipient automatically receives a license from the original licensor to copy, distribute or modify the Program subject to these terms and conditions. You may not impose any further restrictions on the recipients’ exercise of the rights granted herein. You are not responsible for enforcing compliance by third parties to this License.

7.If, as a consequence of a court judgment or allegation of patent infringement or for any other reason (not limited to patent issues), conditions are imposed on you (whether by court order, agreement or otherwise) that contradict the conditions of this License, they do not excuse you from the conditions of this License. If you cannot distribute so as to satisfy simultaneously your obligations under this License and any other pertinent obligations, then as a consequence you may not distribute the Program at all. For example, if a patent license would not permit royalty-free redistribution of the Program by all those who receive copies directly or indirectly through you, then the only way you could satisfy both it and this License would be to refrain entirely from distribution of the Program.

If any portion of this section is held invalid or unenforceable under any particular circumstance, the balance of the section is intended to apply and the section as a whole is intended to apply in other circumstances.

It is not the purpose of this section to induce you to infringe any patents or other property right claims or to contest validity of any such claims; this section has the sole purpose of protecting the integrity of the free software distribution system, which is implemented by public license practices. Many people have made generous contributions to the wide range of software distributed through that system in reliance on consistent application of that system; it is up to the author/ donor to decide if he or she is willing to distribute software through any other system and a licensee cannot impose that choice.

This section is intended to make thoroughly clear what is believed to be a consequence of the rest of this License.

8.If the distribution and/or use of the Program is restricted in certain countries either by patents or by copyrighted interfaces, the original copyright holder who places the Program under this License may add an explicit geographical distribution limitation excluding those countries, so that distribution is permitted only in or among countries not thus excluded. In such case, this License incorporates the limitation as if written in the body of this License.

9.The Free Software Foundation may publish revised and/or new versions of the General Public License from time to time. Such new versions will be similar in spirit to the present version, but may differ in detail to address new problems or concerns.

Each version is given a distinguishing version number. If the Program specifies a version number of this License which applies to it and “any later version”, you have the option of following the terms and conditions either of that version or of any later version published by the Free Software Foundation. If the Program does not specify a version number of this License, you may choose any version ever published by the Free Software Foundation.

10.If you wish to incorporate parts of the Program into other free programs whose distribution conditions are different, write to the author to ask for permission. For software which is copyrighted by the Free Software Foundation, write to the Free Software Foundation; we sometimes make exceptions for this. Our decision will be guided by the two goals of preserving the free status of all derivatives of our free software and of promoting the sharing and reuse of software generally.

NO WARRANTY

11.BECAUSE THE PROGRAM IS LICENSED FREE OF CHARGE, THERE IS NO WARRANTY FOR THE PROGRAM, TO THE EXTENT PERMITTED BY APPLI- CABLE LAW. EXCEPT WHEN OTHERWISE STATED IN WRITING THE COPYRIGHT HOLDERS AND/OR OTHER PARTIES PROVIDE THE PROGRAM “AS IS” WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESSED OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABIL- ITY AND FITNESS FOR A PARTICULAR PURPOSE. THE ENTIRE RISK AS TO THE QUALITY AND PERFORMANCE OF THE PROGRAM IS WITH YOU. SHOULD THE PROGRAM PROVE DEFECTIVE, YOU ASSUME THE COST OF ALL NECESSARY SERVICING, REPAIR OR CORRECTION.

12.IN NO EVENT UNLESS REQUIRED BY APPLICABLE LAW OR AGREED TO IN WRITING WILL ANY COPYRIGHT HOLDER, OR ANY OTHER PARTY WHO MAY MODIFY AND/OR REDISTRIBUTE THE PROGRAM AS PERMITTED ABOVE, BE LIABLE TO YOU FOR DAMAGES, INCLUDING ANY GENERAL, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OR INABILITY TO USE THE PROGRAM (INCLUDING BUT NOT LIMITED TO LOSS OF DATA OR DATA BEING RENDERED INACCURATE OR LOSSES SUSTAINED BY YOU OR THIRD PARTIES OR A FAILURE OF THE PROGRAM TO OPERATE WITH ANY OTHER PROGRAMS), EVEN IF SUCH HOLDER OR OTHER PARTY HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.

Downloaded From TV-Manual.com Manuals

Image 91
Contents Series For Your Records FCC Declaration of ConformityContents Outdoor Antenna Grounding Replacement PartsIf Your TV Gets Damaged Installation NotesImportant Information About Your TV TV SoftwareSpecial Features of Your TV Remote Control Batteries Package ContentsWall-Mounting Stand InstallationWelcome screen First-Time Power-OnHome Fast Power On Retail Before You BeginTV Controls Remote ControlIR Sensor Power IndicatorSystem Reset TV Control PanelMemorizing Channels with Channel Scan For the ANT input Setting Up TV InputsSetting Up Other Inputs Channel Scan for Digital ChannelsAbout Auto Input Sensing Auto Output Sensing Watching DVDs or Videos CancelBasic TV Operation Watching Broadcast TVOther Information Making Picture AdjustmentsAudio Settings Other TV FeaturesPicture Quality Cable ManagementAuto Input/Auto Output Sensing Connection TypesInputs and Outputs Connector PanelsVideo Composite Video ANT AntennaHdmi Inputs High-Definition Multimedia Interface Pb Pr Component VideoUSB IR-NetCommand Output/External Controller InputRS-232C LAN USBa, USBb Suitable for use with Sound Projector surround sound Pb Pr Component Video DeviceHdmi Device Hdtv Cable Box, Satellite Receiver, DVD/ Blu-ray PlayerCable Box, Satellite Receiver, DVD Player Antenna or Cable TV ServiceDVI Video Device Composite Video DeviceAntenna or Wall Outlet Cable VCR or DVD Recorder to anReceiver with Hdmi Output ReceiverDVD player Audio-Only Device SubwooferSelecting an Input Sleep TimerSleep ChannelView Channel Listings Controlling A/V Receiver VolumeRedirecting Audio Output Standard-Definition Digital Channels Status DisplayAbout Channel Numbers Standard-Definition Analog ChannelsTV Display Format Definitions TV Signals and Display FormatsSignal Definitions DVD Image DefinitionsDigital DVI Connecting a Computer to the TVThis TV accepts digital computer signals only Computer Video Connection Audio Video OutputComputer Display Formats Using the TV with a Personal ComputerComputer Video Adjustments Image ResolutionDisplaying the Menu Camera Images and Music FilesUSB Media Player Menu Playing a Slide Show or PlaylistPicture Files Compatible with the USB Port Thumbnail and Playlist Menus USB Media Setup MenuSlideshow + Music --Slideshow Music only Press ACTIVITY, select Watch Movie Cam, and press Enter Photos and Moving Video As Composite VideoBefore You Begin Basic SetupSound Projector Sound Projector TechnologyCustom menu Adjusting Beam AnglesAdjusting Levels Adjusting an External SubwooferInitial Preparation Auto SetupMicrophone Placement Start Auto Setup Press Menu and go to Initial SoundProStandard Connection Vudu Wireless KitInfo & Settings menu Streaming Internet Movies with VuduGetting Started TroubleshootingIntroduction to Home-Theater Control Source device connected directly to the TVMenu Navigation Main MenuAdjust From the Adjust Audio menu Language Audio Listen To StereoMono SAPAdvanced Picture Global ResetFilm Mode Auto, Off Enter twiceADV2 Captions on Analog Channels CaptionsCaptions on Digital Channels DST InitialAnt Cable Adding/Deleting Channels Using the Channel Edit MenuEnergy Energy Usage Standard Fast Power Channel Ant AirStart AVR InputsDVD DVD2 DVR How is the Activity Menu Generated?Inputs Activity menu Photos MusicLock Parental Panel Lock by TimeLock Time Unlock TimeImportant Note on NetCommand About NetCommand IR ControlPower key IR Emitter PlacementIf You are Unable to Locate a Device’s IR Sensor Adding or Removing Device Keys from NetCommand Control Initial NetCommand SetupIf the device has no Power OFF key, skip this step Special Operation Methods Operating NetCommand-Controlled DevicesSpecial Operation Description and Setup How to Use Controlling Most Device TypesSP/EP More Key Menu and NetCommandNetCommand Specialized Device Keys With Any Connection Type Switching Audio to and from the A/V ReceiverControlling A/V Receiver Power Controlling Other A/V Receiver FunctionsBefore You Begin Setting Up A/V Receiver ControlPower and Volume Setup to Control A/V Receiver Power and VolumeUse this setup for Automatic Switching Audio or Audio/VideoDVD Input key More About Using an Hdmi Connection Case 3 Automatic Audio Video Switching via HdmiBefore You Begin Open the Inputs Learn menu NetCommand and press EnterAppendices Series Supplemental Keys Appendix a Programming the Remote ControlFunctions Available for Other A/V Devices More MenusCABLE/SAT VCR DVD Audio Programming the Remote ControlAudio Lock Universal A/V Receiver Control DVDAudio Amplifiers Programming CodesCable Boxes VCRs Satellite ReceiversGFM DVD and Blu-ray Players SVAIRT New Device Found screen 249 Series. Use the TV’s NetCommand IR controlAppendix B Hdmi Control of CEC Devices Enabling Hdmi Control of CEC DevicesDevice Found screen will appear Hdmi Control of an Hdmi A/V Receiver and Connected DevicesResolving CEC Conflicts Using Hdmi ControlCare of the Remote Control Cleaning RecommendationsAppendix C TV Care Bypassing the Parental Lock Mitsubishi Unisen LCD HdtvThis page intentionally left blank Service Appendix E TroubleshootingTV Reset Comparison Guide Service and Customer SupportTions Nels, see Initial ChannelIf the New Device Read the ON-SCREENReset Parental Password SeriesAccount TV Power On/Off Symptom Remarks TV Channels Symptom RemarksSound Symptom Remarks Picture Symptom RemarksReceiver with Hdmi Control Receiver Set Up for Audio and Video Switching overAppendices87 Trademark and License Information Mitsubishi TV Software GNU General Public License No Warranty This Limited Warranty does not Cover To Obtain Warranty ServiceWarranty93 Index Index95 System Reset MDEAservice@mdea.com