EchoStar MT2 Removing the OTA Module, Unplug the receiver’s power cord from the electrical outlet

Page 10

REMOVING THE OTA MODULE

Do not remove the OTA Module unless necessary as you will no longer be able to tune to your over-the-air channels if the module is removed.

1.Unplug the receiver’s power cord from the electrical outlet.

2.Disconnect any cables connected to the module’s OVER THE AIR ANTENNA IN port and/or CH 3-4 OUT port.

3.Remove the screws connecting the module to the receiver’s back panel. Gently remove the module.

4.Replace the module port cover and attach it to your receiver using the screws that had connected the module.

5.Plug the receiver’s power cord into the electrical outlet, and turn it back on.

6.Store the OTA Module in the original box when it is not installed in the receiver.

Page 9

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Important Safety Instructions Installation and Setup Table of ContentsInstallation and Setup IntroductionRemoving the Cover Installing the MT2 OTA Module Connecting the Over-the-Air Antenna Setting up the Receiver to Display OTA Channels Connecting to a TV Using the Channel 3-4 Output System Setup, Installation, then Modulator Setup Modulator SetupUnplug the receiver’s power cord from the electrical outlet Removing the OTA ModuleTroubleshooting Receiver does not detect that the OTA Module is installedPage About OVER-THE-AIR TV Broadcasts Installation Considerations Limited Warranty Advance Exchange Program Dish Network’s Exchange ProgramsPost Receipt Exchange Program Accessory Warranty If You Need Help
Top Page Image Contents