EchoStar manual Installing the MT2 OTA Module

Page 5

The module port on the back of the satellite receiver must be covered if an OTA Module is not installed. Damage to an uncovered module port is not covered by the receiver’s Limited Warranty.

3.Install the module into the module port, making sure the labeling on the module is right-side up. Attach the module using the two cover screws (see Figure 2).

Note: Save the module port cover in case you need to remove the module and cover the port in the future.

Figure 2. Installing the MT2 OTA Module

Page 4

Image 5

Contents Important Safety Instructions Table of Contents Installation and SetupIntroduction Installation and SetupRemoving the Cover Installing the MT2 OTA Module Connecting the Over-the-Air Antenna Setting up the Receiver to Display OTA Channels Connecting to a TV Using the Channel 3-4 Output Modulator Setup System Setup, Installation, then Modulator SetupRemoving the OTA Module Unplug the receiver’s power cord from the electrical outletReceiver does not detect that the OTA Module is installed TroubleshootingPage About OVER-THE-AIR TV Broadcasts Installation Considerations Limited Warranty Post Receipt Exchange Program Dish Network’s Exchange ProgramsAdvance Exchange Program If You Need Help Accessory Warranty