EchoStar MT2 manual Setting up the Receiver to Display OTA Channels

Page 7

Setting up the Receiver to Display OTA Channels

1.Using the remote control, press MENU, select System Setup, then Local Channels.

Note: Your Local Channels screen may differ slightly.

Figure 2. Local Channels Screen

2.Scan for channels by selecting Scan Locals.

Note: Ensure the Analog Type on the HDTV Setup menu (accessed by MENU, System Setup, then HDTV Setup) is set to Offair.

3.The scan takes a few minutes to complete. If you want to stop the scan before it is completed, select Cancel. When the scan completes, the results show how many digital over-the-air channels were found.

4.Select OK to go back to the Local Channels screen and view the list of channels.

5.If you want to name the over-the-air channels, follow the steps below. Otherwise, select Done to save the channel list.

Page 6

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Important Safety Instructions Table of Contents Installation and SetupIntroduction Installation and SetupRemoving the Cover Installing the MT2 OTA Module Connecting the Over-the-Air Antenna Setting up the Receiver to Display OTA Channels Connecting to a TV Using the Channel 3-4 Output Modulator Setup System Setup, Installation, then Modulator SetupRemoving the OTA Module Unplug the receiver’s power cord from the electrical outletReceiver does not detect that the OTA Module is installed TroubleshootingPage About OVER-THE-AIR TV Broadcasts Installation Considerations Limited Warranty Advance Exchange Program Dish Network’s Exchange ProgramsPost Receipt Exchange Program If You Need Help Accessory Warranty
Top Page Image Contents