EchoStar MT2 manual System Setup, Installation, then Modulator Setup

Page 9

a similar name. Refer to your TV’s User Guide for help locating this connection.

4.Using the satellite receiver’s remote control, press MENU, select

System Setup, Installation, then Modulator Setup.

Figure 3. Modulator Setup

5.Under TV1 Out, select Channel 3 or 4. Set the channel on the TV connected to the CH 3-4 OUT output to match this setting.

6.Select Done to save your changes.

Page 8

Image 9

Contents Important Safety Instructions Table of Contents Installation and SetupIntroduction Installation and SetupRemoving the Cover Installing the MT2 OTA Module Connecting the Over-the-Air Antenna Setting up the Receiver to Display OTA Channels Connecting to a TV Using the Channel 3-4 Output Modulator Setup System Setup, Installation, then Modulator SetupRemoving the OTA Module Unplug the receiver’s power cord from the electrical outletReceiver does not detect that the OTA Module is installed TroubleshootingPage About OVER-THE-AIR TV Broadcasts Installation Considerations Limited Warranty Dish Network’s Exchange Programs Advance Exchange ProgramPost Receipt Exchange Program If You Need Help Accessory Warranty