EchoStar MT2 manual Connecting the Over-the-Air Antenna

Page 6

4.Connect the cable from your over-the-air antenna to the OVER-THE- AIR ANTENNA IN port on the module (see Figure 3). Only one cable is needed because the module has an internal splitter to provide the dual-OTA tuner capability.

OVER-THE-AIR

ANTENNA

Figure 3. Connecting the Over-the-Air Antenna

5.Plug the receiver’s power cord into the electrical outlet. Turn the receiver back on after it has reset itself.

Page 5

Image 6

Contents Important Safety Instructions Installation and Setup Table of ContentsInstallation and Setup IntroductionRemoving the Cover Installing the MT2 OTA Module Connecting the Over-the-Air Antenna Setting up the Receiver to Display OTA Channels Connecting to a TV Using the Channel 3-4 Output System Setup, Installation, then Modulator Setup Modulator SetupUnplug the receiver’s power cord from the electrical outlet Removing the OTA ModuleTroubleshooting Receiver does not detect that the OTA Module is installedPage About OVER-THE-AIR TV Broadcasts Installation Considerations Limited Warranty Dish Network’s Exchange Programs Advance Exchange ProgramPost Receipt Exchange Program Accessory Warranty If You Need Help