EchoStar MT2 manual Installation and Setup, Table of Contents

Page 2

TABLE OF CONTENTS
INTRODUCTION	2
INSTALLATION AND SETUP	2
Installation Considerations	2
Installing the MT2 Module	3
Setting up the Receiver to Display OTA
Channels	6
Viewing Your OTA Channels	7
CONNECTING TO A TV USING THE
CHANNEL 3-4 OUTPUT	7
REMOVING THE OTA MODULE	9
TROUBLESHOOTING	10
ABOUT OVER-THE-AIR TV BROADCASTS ...	12
Installation Considerations	13
Digital Transition Consideration	13
LIMITED WARRANTY	14
DISH NETWORK’S EXCHANGE PROGRAMS.15
ADVANCE EXCHANGE PROGRAM	15
POST RECEIPT EXCHANGE PROGRAM	15
ACCESSORY WARRANTY	16
IF YOU NEED HELP	16

Page 1

Image 2

Contents Important Safety Instructions Installation and Setup Table of ContentsInstallation and Setup IntroductionRemoving the Cover Installing the MT2 OTA Module Connecting the Over-the-Air Antenna Setting up the Receiver to Display OTA Channels Connecting to a TV Using the Channel 3-4 Output System Setup, Installation, then Modulator Setup Modulator SetupUnplug the receiver’s power cord from the electrical outlet Removing the OTA ModuleTroubleshooting Receiver does not detect that the OTA Module is installedPage About OVER-THE-AIR TV Broadcasts Installation Considerations Limited Warranty Post Receipt Exchange Program Dish Network’s Exchange ProgramsAdvance Exchange Program Accessory Warranty If You Need Help