Kathrein MSK 33, 9986492 manual List of the command abbreviations

Interfaces

List of the command abbreviations

General commands

TTY		Switch over from the ANSI terminal (menu-orientated operation according to the SAA standard)
		into the TTY terminal mode (line-oriented operation).
ANS		Switch over from the TTY terminal mode (line-orientated operation) to the NASI terminal mode (menu-
		orientated operation according to SAA standard.
?		Request a list of the command abbreviations (functions only in TTY mode).
VER		Request a list of version numbers for the signal hardware and software components of the MSK 33.
PAS		The locked-in password can be newly assigned.
		(max. 16 characters).
LAN		The language of the help guide via modem can be switched between German and English.
Switch-over of the operating type of the MSK 33
SAT		Switch over the MSK 33 into operating type satellite reception.
TV-		Switch over the MSK 33 into operating type cable reception.
FM-		Switch over the MSK 33 into the operating type FM reception.
Measurements with the MSK 33
RF-		The level of the carrier of the receiving signal is measured.
BIA		The current supply form the antenna socket for the satellite LNB or the cable head amplifier is measured.
Changing	settings of the MSK 33
FRE		Enter-in the frequency of the desired transmitter
		Entry:	Action:
		FRE <RET>	You are asked for the frequency.
		FRE 266 <RET>	266 MHz are set as default.
		FRE 10.7 G <RET>	10700 MHz are set as default.
		Note: The comma position	must be entered in as a point.
CHA		Enter in the channel of the desired transmitter (only in TV mode).
		Entry:	Action
CHA<RET>			You are asked for the channel.
		CHA 14 <RET>	14 is set.
		CHA s 16 <RET>	Special channel 16 is set.
LO-		Set LNB oscillator of the	satellite system (only in Sat-mode).
		Entry:	Action:
		LO-<RET>	You are asked for the frequency.
		LO-9750 <RET>	9750 MHz are set as default.
		LO-10.7 G <RET>	10700 MHz are set.
		Note: The comma position	must be enter-in with a point. If LO-0 is entered, the entered frequency is
		interpreted as 1.IF.
22 k		The 22KHz switching signal on the antenna connection is activated or deactivated.
SUP		Activated supply voltage for LNB or cable head station and set or deactivate to a voltage.
		Entry:	Action:
		SUP <RET>	You are asked for the voltage.
		SUP 14.5 <RET>	14.5 volts are set. The unit, volt, does not have to be given.
		SUP 0 V	The supply voltage is deactivated.
		Note: The set voltage is	separately administered for the single operating types of the MSK 33.
Producing		digital control
DIS		the DiSEqC control signal is edited and transmitted.
		Entry:	Action:
		DIS <RET>	You are asked for the Hex-byte(s) which are to be sent.
		DIS E0 12 01 12	The combination FRAME-Byte, ADDRESS-Byte, COMMAND-Byte + max. 3
		34 <RET>	DATEN-Bytes are transmitted.
VSE		The VSEQ control signal is	edited and transmitted. VSEQ
		Entry:	Action:
		VSE <RET>	You are asked for hex-byte which is to be sent.
		VSE E0 <RE>	The entered-in byte is transmitted.

94