3.SETUP
Charging the battery
The battery charger runs on 100~240 VAC, 50/60 Hz.
On the supplied battery charger, the LED will light green to indicate that the battery is fully charged. The LED on the battery charger will light red to indicate that the battery is charging.
Please see the following instructions for charging the battery.
1.Disconnect the power cable between the Satellite™
2.Turn the power switch to the Satellite™
3.Plug in the supplied battery charger.
4.Allow to fully charge until the LED indicator on the supplied battery charger turns green when connected. This indicates a full charge.
5.For best results, charge for 8~10 hours.
The LED on the supplied battery charger will also light green if it is not connected to the Satellite™
Always connect the charger to a switched circuit. Never connect the fixture to a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used only as a 0 to 100% switch.
In order to get an even charge and ensure a long battery life, disconnect the light from the battery before connecting the battery charger. Then, allow the battery to fully charge before using it.
Storing the Product
In order to maintain a long life for the internal battery, the following procedures for storage must be followed.
1.Always recharge the battery every 30 days.
2.Never leave the battery charging for longer than 12 hours.
3.If planning on storing for longer than 30 days, store in a location below 80° F
3. Setup | 7 | 12/28/2009 12:38 PM |