CONNECTION AND SET-UP
TV AND VIDEO RECORDER CONNECTION
Connect the satellite receiver (Cinch socket) and the TV set (Scart socket) using the Cinch to Scart cable supplied, or connect both units (Scart sockets) using a Scart cable (see “Connection Example”). If your TV has a stereo feature, you can receive the sound in stereo via the Scart connection. Use a further Scart cable to connect the satellite receiver (VCR/Scart socket) to the video recorder/PVR.
For system reasons, the same video signals are to be found at the TV Scart socket as at the video cinch output.
If you are recording using an external video recorder, remember not to operate the receiver during recording, otherwise all the
AUDIO CONNECTION
If you want to play the sound on your
OPTICAL/ELECTRICAL DIGITAL OUTPUT
The
INSERTING BATTERIES INTO THE REMOTE CONTROL
Remove the cover on the rear of the remote control.
Insert the two supplied batteries into the remote control. Ensure correct polarity of the batteries; the
+and - markings are indicated inside the battery compartment. Slide the cover back into the housing until it locks in place.
INSTALLING THE UFS 740sw USING THE MOUNTING KIT
The mounting kit supplied offers you the option not only of placing the receiver only a solid flat surface, but also of fixing it in place and of suspending it (e.g. underneath a shelf).
When selecting the mounting location, take care that it conforms to the instructions in the chapter “Safety Instructions”! Note the need to access the connection sockets at the rear of the receiver and allow sufficient space for the cables once connected!
10