FIRST INSTALLATION
Satellites and position
Use the buttons to set the desired satellite (selection from 17
LNB settings
Here use the buttons to select the LNB type used in your system. The choice is between “Universal” and
Universal:
No further input required, since all necessary frequency ranges are covered by a universal LNB.
If you choose not to use a universal LNB, you must here set the frequency ranges for which your LNB was configured.
Use the buttons to select the frequency range to be changed (low, high or limit frequency).
Use the buttons or the digital input buttons to set the exact frequency for which your LNB was configured.
Test transponder
To check whether the settings that you have
made are | correct, | use | the |
| buttons |
to move | to the | “Test | transponder” | field. | |
Use the buttons to select the required transponder from the various ones listed. If your settings are correct, you will see at the top right of the screen the live signal of a channel for the currently selected transponder.
If you are not receiving a signal, check your settings again and if necessary call for expert help.
You have now completed all settings for the first
satellite. Press the button to return to the “Satellite Selection Menu” and perform the settings in the same way for the remaining satellites.
The notes on first installation are unified once again from this point!
When you have finished configuring the satellite press the ! (green) button. The receiver then auto- matically calls up the selection menu for the channel search:
19