Kathrein UFS 740sw manual Transponder frequency

CHANNEL SEARCH (CHANNEL SCAN)

The  buttons allow you to select different sets of parameters for the scan.

Satellite

Use the  buttons to select the satellite on which the transponder you wish to scan is located. Make sure your reception system is aligned to the selected satellite. You can scan only one transponder at a time. If you wish to scan several transponders on a satellite, you should start an automatic scan of the transmitting satellite.

Press the  button to move to the next selection item.

Transponder frequency

Select the transponder to be scanned, using the  buttons or the keypad. At the bottom right of the screen display, the receiver shows the current signal strength and signal quality of the selected

transponder. Press the  button to move to the next selection item.

Channel scan mode

Use the  buttons to select whether you wish to scan “free & scrambled”, “only free” or “only scrambled” channels.

To view encrypted channels you need the appropriate CA (Conditional Access) module and a valid smart card together with a valid subscription to the respective Pay-TV provider.

Press the  button to move to the next selection item.

Network scan

Use the  buttons (On/Off) to select whether a network scan should be performed. If you set the network scan to “Off”, only the factory stored transponders of the satellites you previously selected will be scanned for new as yet unlisted channels.

If you set the network scan to “On”, the transponder network enables additional transponders that have not yet been stored to be located. They are then stored and scanned for new channels in the same way as the existing transponders.

When you have made your settings, use the buttons to select “Start Search” and press the button to start scanning. You can cancel the scan at any time by pressing the  button.

During the scan you will see a display that shows you the progress of the scan and the channels found so far. Newly found channels are identified with the designation “New” after the channel name.

After completion of the scan, you will see the following message (example):

62