Woods Equipment 1013460 Torque Mounting Hardware, Attach Backhoe Mounts to Backhoe

Torque Mounting Hardware

	TORQUE SPECIFICATIONS
			Wrench
Ref	Cap Screw	Qty	Size	Required Torque
16	1/2 NC x 6	4	1/2"	85 lbs-ft (115 N-m)
18	1/2 NC x 1-3/4	4	1/2"	85 lbs-ft (115 N-m)
19	M16 x 2.0P x 70 mm	4	24 mm	125 lbs-ft (169 N-m)
20	M16 x 2.0P x 55 mm	4	24 mm	125 lbs-ft (169 N-m)
24	M16 x 2.0P x 40 mm	2	24 mm	125 lbs-ft (169 N-m)
26	5/8 NC x 2	8	15/16"	170 lbs-ft (230 N-m)
28	5/8 NC x 3	4	15/16"	170 lbs-ft (230 N-m)

Attach Backhoe Mounts to Backhoe

NOTE: Leave all hardware loose until backhoe has		3.	1013464	Right backhoe mount
been mounted to the tractor.		4.	1013465	Left backhoe mount
1.	Attach right backhoe mount (3) and left backhoe	10.	1012852	Crossmember, link 6500
	mount (4) to backhoe frame.	15.	1093	1/2 NC Hex nut
2.	Secure into position using six (three per bracket)	17.	1450	3/4 NC Hex nut
	cap screws (25), hardened flat washers (21), and			(BH6500, BH7500 only)
		18.	24576	1/2 NC x 1-3/4 Cap screw GR5
	hex nuts (17).
3.	Secure crossmember (10) to backhoe brackets	21.	57798	3/4 Hardened flat washer
		22.	57816	1/2 Hardened flat washer
	using four cap screws (18), hardened flat wash-
	ers (22), and hex nuts (15).	25	735	3/4 NC x 2 Cap screw GR5

Figure 15. Backhoe Mounts Installed Figure 16. Backhoe Mount Installation

10Installation

(Rev. 5/2/2008)

MAN0406 (Rev.9/7/2007)