Woods Equipment 1013460 installation manual Safety Rules

Page 3

SAFETY RULES

ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!

!LEA EL INSTRUCTIVO!

Si no lee Ingles, pida ayuda a alguien que si lo lea para que le traduzca las medidas de seguridad.

„Make sure that all operating and service person- nel know that if hydraulic fluid penetrates skin, it must be surgically removed as soon as possible by a doctor familiar with this form of injury or gan- grene, serious injury, or death will result. CON-

TACT A PHYSICIAN IMMEDIATELY IF FLUID ENTERS SKIN OR EYES. DO NOT DELAY.

Safety is a primary concern in the design and manufacture of our products. Unfortunately, our efforts to provide safe equipment can be wiped out by an operator’s single careless act.

In addition to the design and configuration of equipment, hazard control and accident preven- tion are dependent upon the awareness, con- cern, judgement, and proper training of personnel involved in the operation, transport, maintenance, and storage of equipment.

It has been said, “The best safety device is an informed, careful operator.” We ask you to be that kind of operator.

„This Sub-Frame Mounting Kit is only for the backhoes and tractors specified in the Sub-Frame Mount Installation section of this manual. Any other use or modification of this mounting kit may result in serious injury or death.

„Hydraulics must be connected as instructed in this manual. Do not substitute parts, modify, or connect in any other way.

„After connecting hoses, check that all control lever positions function as instructed in the Opera- tor's Manual. Do not put into service until control lever and equipment movements are correct.

„Safety instructions are important! Read all attachment and power unit manuals; follow all safety rules and safety decal information. (Replace- ment manuals and safety decals are available from your dealer. To locate your nearest dealer, check the Dealer Locator at www.WoodsEquipment.com, or in the United States and Canada call 1-800-319- 6637.) Failure to follow instructions or safety rules can result in serious injury or death.

„Know your controls and how to stop engine and attachment quickly in an emergency.

„Keep hands and body away from pressurized lines. Use paper or cardboard, not hands or other body parts to check for leaks. Wear safety goggles. Hydraulic fluid under pressure can easily penetrate skin and will cause serious injury or death.

„To prevent contamination during maintenance and storage, clean and then cover hose ends, fit- tings, and hydraulic ports with tape.

„Check that all hardware is properly installed. Always tighten to torque chart specifications unless instructed otherwise in this manual.

„This mounting kit is designed to provide secure mounting and adequate operator clearance for most operators when properly installed. Check clearance dimensions shown below to be sure you have installed seat bracket correctly. In some cases it may be necessary to adjust the seat to the lowest position and/or as far forward as possible in order to achieve the ideal 40-inch clearance. For 36.5-inch radius operation, taller operators may need to wear a hardhat for greater comfort and safety.

„Air in hydraulic systems can cause erratic oper- ation and allows loads or equipment components to drop unexpectedly. When connecting equipment or hoses or performing any hydraulic maintenance, purge any air in hydraulic system by operating all hydraulic functions several times. Do this before putting into service or allowing anyone to approach the equipment.

„Protective hose sleeves must cover all hydrau- lic hoses within 20 inches of the operator and be secured onto metal hose fittings. Replace hoses or sleeves if damaged or if protective sleeve cannot be properly positioned or secured.

(Safety Rules continued on next page)

4-Point SFMK (Rev. 5/8/2006)

Safety 3

Image 3
Contents Installation Manual To the Dealer IntroductionSafety Rules SafetySafety Rules from previous Installation Backhoe SUB-FRAME InstallationTractor Preparation With Woods LS84 Loader Mount Install Front MountsTractor Brackets Installed with LS84 Loader Install Tractor BracketsTractor Bracket Installation Install Offset Bars Install Cross BraceAttach Backhoe Mounts to Backhoe Torque Mounting HardwareAssemble Bulkhead Bracket Hydraulic InstallationInstall Hydraulic Hoses Install Hydraulic Block and FittingsInstall Bulkhead Adapter on Backhoe Mount Install Hoses to Backhoe ValveInstall Rear Tires Mount Backhoe Mount Backhoe to Tractor Check Hydraulic SystemRefer to Figure Mount Backhoe to TractorBackhoe Storage Position Remove Backhoe from TractorAttach 3-Point Arms Connect Hydraulic Hoses1013460 4-POINT SUB-FRAME Mounting KIT PartsHose KIT Appendix Bolt Torque ChartAbbreviations Bolt Size ChartWarranty Part or MAN0406