Tractor Bracket Installation | Woods Equipment 1013460 specs

Install Tractor Brackets

1.Place left tractor bracket (2) under left side of tractor. Use a hydraulic floor jack to help raise and hold tractor bracket in position.

2.Attach left tractor bracket to left front mount (8) using two cap screws (26), hardened flat washers (23), and hex nut (27).

NOTE: Tractors equipped with mid-mount mower, place tractor bracket on the inside of front mount as shown in Figure 9. Tractors without mid-mount mower, place on the outside of front mount.

3.Attach tractor bracket to the bottom of rear axle using two cap screws (16), four hardened flat washers (22), hex nuts (15), and modified spacer.

NOTE: Place tractor spacer between ROPS brackets with flange on top.

4.Repeat steps to install right tractor bracket (1).

Figure 9. Left Tractor Bracket Attached

to Front Mount

1.1013462 Right tractor bracket

2.1013463 Left tractor bracket

8.1013475 Left front mount

9.1026847 Right front mount

15.1093 1/2 NC Hex nut

16.13563 1/2 NC x 6 Cap screw GR5

22.57816 1/2 Hardened flat washer

23.57817 5/8 Hardened flat washer

26.902 5/8 NC x 2 Cap screw GR5

27.230 5/8 NC Hex nut

Figure 10. Tractor Bracket Installation

8 Installation	MAN0406 (Rev.9/7/2007)