Install Cross Brace
1. | Remove PTO shield. | 7. | 1013474 | Cross brace |
|
| |||
2. | Attach cross brace (7) to rear of tractor using two | 15. | 1093 | 1/2 NC Hex nut |
| cap screws (24) and hardened flat washers (23). | 18. | 24576 | 1/2 NC x |
|
| |||
3. | Attach to right and left tractor brackets using four | 22. | 57816 | 1/2 HArdened flat washer |
| (two per side) cap screws (18), hardened flat | 23. | 57817 | 5/8 Hardened flat washer |
| washers (22), and hex nuts (15). | 24. | 64062 | M16 x 2.0P x 40 mm Cap screw |
|
|
4.Install PTO shield.
18
23
24
Figure 11. Cross Brace InstalledFigure 12. Cross Brace Installation
Install Offset Bars
1. | Place right offset bar (5) on the outside of right | 5. | 1013472 | Right offset bar |
| tractor bracket. | 6. | 1013473 | Left offset bar |
2. | Secure to front holes using two cap screws (26), | 23. | 57817 | 5/8 Hardened flat washer |
| hardened flat washers (23), and hex nuts (27). | 26. | 902 | 5/8 NC x 2 Cap screw GR5 |
3. | Secure to rear holes using two cap screws (28), | 27. | 230 | 5/8 NC hex nut |
| hardened flat washers (23), and hex nuts (27). | 28. | 34473 | 5/8 NC x 3 Cap screw GR5 |
4.Repeat steps to install left offset bar (6).
Figure 13. Right Offset Bar Installed | Figure 14. Right Offset Bar Installation |
MAN0406 (Rev. 9/7/2007) | Installation 9 |
|
|