Hunter Fan ICR owner manual Maximizing Operating Range

Page 15

NOTE: The ICR remote can activate any station on the controller whether the controller dial is in the “System Off”, “Run” or “Run/Bypass Sensor” modes. If a sensor device has been wired to the controller, the ICR will not override the sensor for manual operation.

Maximizing Operating Range..................................................................

The ICR is designed as an extended range remote that should meet the range requirements for even the largest irrigation systems. The maximum range of transmission will vary from approximately ½ mile to 2 miles depending upon the site terrain and the location of the Receiver.

Listed below are a few steps to assure that you are getting the maximum range possible:

1.Do not install the SmartPort® wiring harness (that the Receiver connects to) near large sources of metal such as power meters, water pipes, and metal siding.

2.Do not install the SmartPort wiring harness in a basement or underground location.

3.For maximum range in all directions from the Receiver, the Receiver antennae should be pointed straight up (vertically). If the Receiver is mounted with its antennae oriented horizontally, reception will be very good if the Transmitter is on either side of the antennae, but poor if it is facing the end of the antennae.

4.When operating the Transmitter, hold the Transmitter as vertical as possible and turn and face the direction of the Receiver even though it may be a long way away.

11

Image 15
Contents ICR For Use with Hunter Controllers Installation InstructionsPage Table of contents TABLa de contenido Introduction ICR Components Transmitter ReceiverSmartPort Carrying Case Installing the SmartPort Wiring Harness SmartPort Wiring HarnessBlue Red White Wiring the SmartPort to hunter controllersSRC Controller SmartPort Installation Pro-C Controller SmartPort InstallationPreparing the Transmitter for Use Typical InstallationsInstalling the Transmitter Batteries Changing the Run TimeTo change the Run Time To change the Maximum Number of Stations Changing the Transmitter AddressChanging the Maximum Number of Stations To change the Transmitter addressChanging the Receiver Address Preparing the Receiver for UseSRC/Pro-C/ICC Controllers ACC/ACC Decoder ControllersTo remotely activate a station or program Activating a Station with the ICR Remote SystemMaximizing Operating Range CAUSes Solutions Troubleshooting GuideDimensions Operating SpecificationsElectrical Specifications Default SettingsPage Presentación del Producto Componentes del ICR Emisor ReceptorSmartPort Caja Instalación del Arnés de Cableado SmartPort Conexión de Cableado del Programador SmartPortInstalación SmartPort del Programador Pro-C Azul Rojo BlancoPreparación del Emisor Antes de su Uso Instalaciones TípicasCambios al Tiempos de Riego Colocación de la Pila del EmisorCambio del Tiempo DEL Ciclo de Riego Para Modificar el Número Máximo de Estaciones Modificación de la Dirección del EmisorModificación del Número Máximo de Estaciones Para Modificar la Dirección del EmisorProgramadores SRC/Pro-C/ICC Preparación del Receptor Antes de su UsoModificación de la Dirección del Receptor Optimización de la Zona de Funcionamiento Problema Causas Soluciones Guía Para Solucionar ProblemasReglaje por falla DimensionesEspecificaciones de Operación Especificaciones EléctricasFCC Compliance Notice