Hunter Fan ICR Changing the Transmitter Address, Changing the Maximum Number of Stations

Page 12

Changing the Transmitter Address...................................................

Both the ICR Transmitter and Receiver have an “address” that they use when communicating. If the addresses do not match, the Receiver will ignore the transmission. Your ICR comes from the factory with both the transmitter and Receiver address set to 0. You may change the address to any value from 0-127 for added security. Note that if you change the Transmitter address, the Receiver must “learn” the new address as described in the “Preparing the Receiver for Use” section.

To change the Transmitter address:

1.If the unit is OFF (no display), power the Transmitter up by pressing any of the buttons for at least 1 second then releasing the button. The Transmitter will illuminate the active station.

2.Press the Mode button until the word “Address” appears on the display. The address will be blinking at this point. If more than 5 seconds go by

without a button being pressed, the Transmitter will revert back to displaying the active station.

3.Use the or button to

change the address to any value

"%%3&44

between 0 and 127. Then do not

 

 

touch any of the buttons for 5 seconds and the display will stop blinking and return back to the active station.

Changing the Maximum Number of Stations..................................

Your ICR Transmitter comes from the factory with the maximum number of stations set to 9. This means that when

you use the or buttons to change the station, you may change it to any number between 1 and 9. However, if you have controllers with more than 9 stations you will want to increase the maximum number of stations.

To change the Maximum Number of Stations:

1.If the unit is OFF (no display), power the Transmitter up by pressing any of the buttons for at least 1 second then releasing the button. The Transmitter will illuminate the active station.



Image 12
Contents For Use with Hunter Controllers Installation Instructions ICRPage Table of contents TABLa de contenido Introduction ICR Components Transmitter ReceiverSmartPort Carrying Case SmartPort Wiring Harness Installing the SmartPort Wiring HarnessWiring the SmartPort to hunter controllers SRC Controller SmartPort InstallationPro-C Controller SmartPort Installation Blue Red WhiteTypical Installations Preparing the Transmitter for UseInstalling the Transmitter Batteries Changing the Run TimeTo change the Run Time Changing the Transmitter Address Changing the Maximum Number of StationsTo change the Transmitter address To change the Maximum Number of StationsPreparing the Receiver for Use SRC/Pro-C/ICC ControllersACC/ACC Decoder Controllers Changing the Receiver AddressActivating a Station with the ICR Remote System To remotely activate a station or programMaximizing Operating Range Troubleshooting Guide CAUSes SolutionsOperating Specifications Electrical SpecificationsDefault Settings DimensionsPage Presentación del Producto Componentes del ICR Emisor ReceptorSmartPort Caja Conexión de Cableado del Programador SmartPort Instalación del Arnés de Cableado SmartPortAzul Rojo Blanco Instalación SmartPort del Programador Pro-CInstalaciones Típicas Preparación del Emisor Antes de su UsoCambios al Tiempos de Riego Colocación de la Pila del EmisorCambio del Tiempo DEL Ciclo de Riego Modificación de la Dirección del Emisor Modificación del Número Máximo de EstacionesPara Modificar la Dirección del Emisor Para Modificar el Número Máximo de EstacionesPreparación del Receptor Antes de su Uso Programadores SRC/Pro-C/ICCModificación de la Dirección del Receptor Optimización de la Zona de Funcionamiento Guía Para Solucionar Problemas Problema Causas SolucionesDimensiones Especificaciones de OperaciónEspecificaciones Eléctricas Reglaje por fallaFCC Compliance Notice