Hunter Fan ICR owner manual Installing the Transmitter Batteries, Changing the Run Time

Installing the Transmitter Batteries.............................................

The ICR transmitter requires 4 AA alkaline batteries. To install the batteries. remove the two screws holding the battery on the back of the transmitter. Drop the batteries into the battery compartment and replace the door. Your transmitter is now ready to operate.

Changing the Run Time...............................................................................

You have the ability to adjust the amount of time that a station will run once it has been turned on by your ICR. This does not affect the run time programmed into your controller. This adjustment is made at the transmitter as described below.

To change the Run Time:

1.If the unit is OFF (no display), power the transmitter by pressing any of the buttons for at least 1 second then releasing the button. The transmitter will illuminate and display the active station.

2.Press the Mode button until the words “Run Time” along

with the current Run Time is displayed. (default is 10 minutes) The Run Time will be blinking at this point. If more than 5 seconds go by

without a button being pressed, the Transmitter will revert back to

displaying the active station.

3. Use the	or	buttons to	36/ 5*.&
change the Run Time to any of
the 8 settings ranging from 1 to
90 minutes. Then do not touch any of the buttons for
5 seconds and the display will stop blinking and return
back to the active station.