Hunter Fan ICR owner manual Transmitter, Receiver, SmartPort Carrying Case

Page 7

This section will provide a brief overview of some of the components on the ICR. Each item will be discussed in further detail later, however, this section can be helpful in getting acquainted with the different options available.

A – Transmitter

1.Transmitter Body – The ICR transmitter is designed to be dirt tolerant and water resistant.

2.LCD Display – Large, easy to read LCD display.

3.Control Buttons – Push button operation.

4.External Antennae – Flexible, removable rubber for maximum radio range.

5.Battery Compartment – The ICR is designed to operate on a four AA alkaline batteries. The batteries easily drop into a battery holder.

6.Belt Clip – Belt clip provides convenient access to the transmitter at all times.

B – Receiver

7.Receiver Body – Rugged, water resistant design.

8.Addressing Button – Allows for easy receiver to . transmitter addressing.

9.External Antennae – Flexible, removable antennae . for maximum range.

C – SmartPort®

D – Carrying Case



Image 7
Contents ICR For Use with Hunter Controllers Installation InstructionsPage Table of contents TABLa de contenido Introduction ICR Components Receiver TransmitterSmartPort Carrying Case Installing the SmartPort Wiring Harness SmartPort Wiring HarnessBlue Red White Wiring the SmartPort to hunter controllersSRC Controller SmartPort Installation Pro-C Controller SmartPort InstallationPreparing the Transmitter for Use Typical InstallationsChanging the Run Time Installing the Transmitter BatteriesTo change the Run Time To change the Maximum Number of Stations Changing the Transmitter AddressChanging the Maximum Number of Stations To change the Transmitter addressChanging the Receiver Address Preparing the Receiver for UseSRC/Pro-C/ICC Controllers ACC/ACC Decoder ControllersTo remotely activate a station or program Activating a Station with the ICR Remote SystemMaximizing Operating Range CAUSes Solutions Troubleshooting GuideDimensions Operating SpecificationsElectrical Specifications Default SettingsPage Presentación del Producto Componentes del ICR Receptor EmisorSmartPort Caja Instalación del Arnés de Cableado SmartPort Conexión de Cableado del Programador SmartPortInstalación SmartPort del Programador Pro-C Azul Rojo BlancoPreparación del Emisor Antes de su Uso Instalaciones TípicasColocación de la Pila del Emisor Cambios al Tiempos de RiegoCambio del Tiempo DEL Ciclo de Riego Para Modificar el Número Máximo de Estaciones Modificación de la Dirección del EmisorModificación del Número Máximo de Estaciones Para Modificar la Dirección del EmisorProgramadores SRC/Pro-C/ICC Preparación del Receptor Antes de su UsoModificación de la Dirección del Receptor Optimización de la Zona de Funcionamiento Problema Causas Soluciones Guía Para Solucionar ProblemasReglaje por falla DimensionesEspecificaciones de Operación Especificaciones EléctricasFCC Compliance Notice